English 9
Congratulations on purchasing your »RF ta-
ble blink lamp«. You have chosen a modern
and reliable receiver for our lisa RF system.
Please read this operating instruction care-
fully to be able to set up the unit correctly
and to familiarise yourself with all of the sys-
tems features.
Standard components
Please check if all of the following compo-
nents are included:
- »RF table blink lamp«
- 12 V plug-in PSU
- Operating Instructions
- Warranty card
Should any parts be missing, please imme-
diately contact your dealer or the manufac-
turer directly.
Function principle
The »RF table blink lamp« picks up signals
from different radio transmitters and converts
them into light signals.
The »RF table blink lamp« has a very pow-
erful light-emitting diode (LED) which brings
a signal to the user’s attention. Further addi-
tional LEDs indicate the nature of the incom-
ing signals.
Controls
Battery/Dead battery
If the »Battery/Dead battery« indicator lights
up constantly, this means that the battery or
rechargeable battery which is inserted is
almost fully discharged. A regular battery
must be replaced or a rechargeable battery
recharged. The »Dead battery« indicator
might flash briefly in the flashing mode; this
does not indicate that the battery is low.
Indicator LEDs
The 6 coloured indicator light-emitting di-
odes (LED) help you to differentiate between
the individual transmitter signals. They light
up for a total of 40 seconds.
lisa-Channel selector
You can select the radio channel using the
channel selector. Make sure all devices in
your system are set to the same channel.
ON-/OFF switch
Set the on/off switch to »ON«. The
»RF table
blink lamp«
is now ready to operate.
After the unit has been switched on, each
of the coloured indicator LEDs will light up
briefly in succession. This forms part of a
self-test of the unit and lets you know that it is
functioning correctly.
OK button
Press the OK button to acknowledge incom-
ing signals. This will switch off the bright blink-
ing LED. The coloured indicator LED lights
will switch off automatically after a total of 40
seconds.
Furthermore, you can press the OK but-
ton to call up the most recent signal again
(the function works for up to 3 minutes after
reception of the signal). The strong white
blinking LED signal will not be repeated.
Note (special accessories)
Vibrating pillow or other modules:
- Acustic module MA-1
- Flash module MF-1
- Switch module MS-1
can be connected to the corresponding
jacks of the »RF table blink lamp«.
