Operation
Special accessories expand the possibilities of using your appliance. Please contact the dealer
for further information.
Install accessories before start-up.
1.lnstall coupling for water connection (pic A).
Screw the coupling to the water connection on the appliance.
2.lnstall high pressure hose (pic B. pic K).
lnsert the high-pressure hose tightly in to coupling on the appliance, it will Iock in
audibly. Note: make sure the connection nipple is aligned correctly. Check the
secure connection by pulling on the high-pressure hose.
3.lnstall trigger gun holder and accessory storage (pic C).
lnsert trigger gun holder and accessory storage. Then push down ail the way.
4. lnstall spray lance (pic F).
Push the spray lance into the trigger gun and fasten it by turning it through 90 degree.
Water supply
lmpurities in the water can damage the high-pressure pump and accessories. Ali high pressure
washer (except hot water system) use the cold water. The suitable water temperature is 5°C to
60°C.
Water supply from mains
Observe regulations of water supply
For connection values, use fibre-reinforced water hose (not included) with a standard coupling,
normally the length is Sm, connect the water hose to the appliance and water supply.
1. Open the water tap
2. Unlock the lever on the trigger gun
3. Pull on the lever of the trigger gun
4. Turn on the appliance (pic G ON: open OFF: close)
Start up
Dry runs lasting longer than two minutes lead to damages to the high-pressure pump.
If the appliance does not build up pressure within two minutes, switch it off and
proceed as instructed in the Chapter "Troubleshooting".
The trigger gun is subjected to recoil force when the water washer is discharged.
Make sure that you have a firm footing and are also holding the trigger gun and spray lance
firmly.
The spray lance is adjustable from stream to fan patterm for easy cleaning (pic H).
Caution
Prior to cleaning, make sure that the high-pressure washer is placed safely on level ground. Wear
protective goggles and protective clothing du ring the cleaning process. Notes: Release the lever
of the trigger gun, the device will switch off aga in. High pressure washer remains in the system.
