EN
45
Installation requirement - electrical connection
WARNING AGAINST ELECTRICAL
TENSION!
THERE IS DANGER TO LIFE !
There are energised parts near this sym-
bol. Covers marked with this symbol may
only be removed by an authorised electri-
cian.
• The electrical connection may only be
carried out by an authorised specialist!
• The statutory regulations and connection
conditions of the local electrical supply
company must be observed in full.
• When the device is connected, a device
must be provided which makes it pos-
sible to disconnect the device from the
mains with an opening width of at least
3 mm all poles using a contact. LS swit-
ches, fuses and contactors are regar-
ded as suitable disconnecting devices.
When connecting and repairing the
device, disconnect it from the power
supply using one of these devices.
• The protective conductor must be long
enough so that if the strain relief fails, it
will only be subjected to tensile stress
after the current-carrying cores of the
connecting cable.
• The excess cable length must be pulled
out of the installation area below the
device.
• Please make sure that the mains volta-
ge is the same as on the nameplate.
• Complete protection against accidental
contact must be ensured by installation.
• Attention: Incorrect connection can lead
to destruction of the power electronics.
• The device is only approved for perma-
nent installation. It must not be connec-
ted with a safety plug.
Connected loads:
Cooker hob Mains voltage:
380-415V 2N~, 50/60Hz
Extractor hood Mains voltage:
220-240V 50Hz
( see also instructions cooktop )
Connecting cable built in by factory
• The hob is equipped with a temperature-
resistant connection cable at the facto-
ry.
• The mains connection plug of the extrac-
tor fan is already present.
• Damaged lines may only be replaced by
the manufacturer or his customer ser-
vice.
