EN
30
PRELIMINARY NOTES
Safety instructions
Installation, connection, startup and repairs may be carried out by technicians only. Technicians
can specify a suitable attachment and exhaust air conduction for the extractor hood. The attach-
ment must be suitable for the weight of the extractor hood and for the load on the wall. Observe
the pullout values of the supplied wall plugs. These have the following values depending on the
wall:
Risk of injury !
The hob structure may have sharp edges caused by the manufacturing process. Please wear
protective gloves during installation to avoid the risk of injury. Prepare the necessary tools before
mounting the hood. For the installation of the hob, on-site requirements must be met to ensure
smooth installation of the hood and kitchen appliances must be covered. Before drilling in the
wall, make sure that no pipes behind it are damaged.
Risk of electric shock !
The mains voltage must correspond with the specifications on the rating plate. The rating plate is
situated near the filters inside the hood. Connect the extractor hood to a correctly installed e-
arthed socket only. The socket must be easily accessible following installation so that the extrac-
tor hood can be isolated if required. If the extractor hood is to be permanently connected (e.g. if
there is no appropriate socket), it may be connected to the mains by an electrician only. If the
extractor hood is to be permanently connected, it must be connected to a single electric circuit
with disconnector. Switches with a contact opening of at least 3 mm and all-pole switches, e.g.
LS switches and contactors, are regarded as disconnectors. Before connecting the extractor
hood to the power supply, disconnect the mains circuit(s). Before drilling fixing holes, ensure that
there are no electric cables which could be damaged by the drilling. When preparing the power
supply connection, ensure that the extractor hood can be connected without difficulty.Observe
local regulations.
Connection to power supply
Check that the rated voltage of the device corresponds to the local mains voltage. Incorrect set-
ting will damage or destroy the device. Before operation, check whether all cables and wires are
faultless and undamaged. In particular, make sure that the cables have no kinks, have not been
laid too short around corners and that there are no objects on the cables. Furthermore, make su-
re that all plug connections are tight. Faulty shielding or wiring endangers your health (electric
shock) and can destroy other equipment. Devices with a mains plug are equipped with a safety-
tested mains cable from the country of use and must only be connected to a properly earthed e-
arth contact socket, otherwise there is a risk of electric shock. Make sure that the socket at the
device or the earth contact socket of the house installation is freely accessible so that the mains
cable can be disconnected from the socket in an emergency or during service or maintenance
work.
Transport, unpacking, installation
Condensation may occur if the appliance is brought into the installation site
from a cold environment. Please wait until the appliance has adjusted to
the temperature and is completely dry before operating it. The acclimatizati-
on period depends on the temperature difference and the type and design
of the appliance. However, it should be at least 12 hours.
Before the cooker hood is shipped, it is subjected to a detailed test by our quality control depart-
ment, during which all functions are tested.
The pictures and drawings used in the operating and assembly instructions may differ from the
model supplied or may contain options which are not included in the scope of delivery.
We reserve the right to make technical changes!
