7
Settings
Tuning the TV set to the recorder
The TV set receives programmes from different
stations on certain channels.
The recorder also transmits on such a channel (bet-
ween channels 30 and 40 ± 2 channels in the UHF
band) to which the TV set must now be tuned.
A “transmitter” is installed in the recorder to assist
you in finding this channel.
w
!
This adjustment is not necessary if the recorder and
the TV set are connected with a EURO-AV cable
(see chapter “Connecting” on page 3).
If necessary, switch the recorder’s transmitter off to
prevent picture interference, see chapter on this
page.
❒
Preparation
Switch the TV set on.
Select the programme position for the video recor-
der at the TV set (AV programme position).
❒
Tuning
Remove the aerial cable from the socket
–
II
–
on the
recorder.
Press the h button on the remote control.
– The recorder “transmits” the info table.
– Display at recorder: »
INFO
«
Search and store the recorder info table at the TV
set – between channels 30 and 40 ± 2 channels in
the UHF band.
– Follow the instructions in the TV set operating
instructions.
Insert the aerial cable in the aerial socket
–
II
–
on the
recorder.
If the picture quality is good, end the setting using
the i button on the recorder.
w
!
If the picture quality is poor, proceed as described
in the next chapter.
❒
Improving the picture quality
If wavy lines are visible on the TV screen, the chan-
nel tuned to is already occupied by a TV station.
In this case, proceed as follows:
Press the i button on the recorder.
On the TV set, search for a channel – in the UHF
band between the channels 30 and 40 ± 2 channels
– which is not occupied by a TV station (only snow
on the picture screen).
2
1
5
4
3
2
1
2
1
Store the channel at the TV set (see the operating
instructions for the TV set).
Press the h button on the remote control.
– The recorder “transmits” the info table.
Using the alignment pin supplied, turn the channel
selector
q (FREQ./MOD.) on the back of the recor-
der (see illustration) slightly to the left or right until
the info table appears on the TV screen.
Reconnect the aerial cable to the socket
–
II
–
on the
recorder.
End the setting using the i button on the recor-
der.
❒
Switching the recorder’s transmitter off
and on
If your recorder receives many TV stations between
the channels 30 and 40 in the UHF band, you may
experience picture interference when using your
recorder. To avoid this, the recorder’s transmitter
may be switched off.
w
!
In order for the picture/sound signal of the recorder
to be passed to the TV set, the two units must be
connected with a EURO-AV cable (see page 3).
To switch the recorder’s transmitter off, press the
¢
CODE button, the numbered buttons
8518, and the G button, in sequence.
– The recorder’s transmitter is switched off.
– Brief display at recorder: »
OFF
«.
To switch the recorder’s transmitter on, press the
¢
CODE button, the numbered buttons
8519, and the G button, in sequence.
– The recorder’s transmitter is switched on.
– Brief display at recorder: »
ON
«.
2
1
7
6
