ENGLISH
49
Displaying signal information
(only for digital television channels)
1 Open the menu with »i«.
– The »PICTURE« menu appears.
2 Select the menu »CHANNEL SETUP« with »
–
« or »
+
«.
3 Select »Signal Information« with »
V
« or »
Λ
« and press »G« to
confirm.
– You will see information on the channel, modulation, quality
and signal strength.
Notes:
The lower section of the menu shows the signal properties. The
further the bar for »Quality« and »Signal Strength« extends to
the right, the better the reception signal.
The signal level not only depends on your receiver system, but
also on the channel which is currently active. Remember this when
aligning your antenna using the signal level display.
4 Press »i« to end the display.
Updating software
(only for digital television channels)
1 Open the menu with »i«.
– The »PICTURE« menu appears.
2 Select the »OPTIONS« menu with »
–
« or »
+
«.
3 Select the »Software Update« menu by pressing »
V
« or »
Λ
«.
4 Press »G« to start the software update.
– The software is updated automatically, if possible.
5 Press »i« to end the setting.
INFORMATION
------------------------------------------------------------------------------
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module Not Inserted
Select
Back
Exit
Active Antenna Power On
s
s
s
s
s
Z
1
OPTIONS
Language Settings
Restore Factory Defaults
Country Deutschland
Game Mode Off
SPDIF Output PCM
Software Update
Select
Back
Exit
s
s
s
Z
1
