700806
1
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
18/39
Grundig Intermedia GmbH
Thomas-Edison-Platz 3
D-63263 Neu-Isenburg
CLOCK RADIO
Sonoclock 3000
www.grundig.com
DEEN
These additives can corrode the
device supports, leaving resi-
dues on the furniture surfaces
which can be difficult or impos-
sible to remove.
Only use the device in a moder-
ate climate.
Do not use any cleaning agent,
as this may damage the casing.
Clean the device with a clean,
moist leather cloth.
Do not expose the back-up bat-
tery to extreme heat, caused for
example by direct sunlight, heat-
ers or fire.
Never open the device casing.
No warranty claims are ac-
cepted for damage caused by
incorrect handling.
Compliance with RoHS Directive
The product you have purchased complies with EU
RoHS Directive (2011/65/EU). It does not contain
harmful and prohibited materials specified in the
Directive.
Package information
Packaging materials of the product are
manufactured from recyclable materials in
accordance with our National
Environment Regulations. Do not dispose
of the packaging materials together with the domes-
tic or other wastes. Take them to the packaging mate-
rial collection points designated by the local authori-
ties.
This device is noise-suppressed according to the
applicable EU directives. This product fulfils the
European directives 2014/53/EU, 2009/125/EC
and 2011/65/EU. You can find the CE declaration
of conformity for the device in the form of a pdf file
on the Grundig Homepage
www.grundig.com/downloads/doc
Power supply:
AC Adaptor Input:100 - 240V
~
, 50/60 Hz 0.25A
Output: 5V 1500mA
Max. Power consumption:
<11W (operation)
<1W (standby)
Output:
USB host: 5V 1A charge out
Back up micro batteries:
Back up DC Batt: 2 x 1.5v UM4/R03/AAA
Frequency bands:
FM 87.5 ...108.0 MHz
Circuit features:
Loudspeaker: 3 inch
Output Power: 2 W
Dimensions:
W x H x L 200 x 120 x 65 cm
Weight: 450 gr
Technical and design modifications reserved.
POWER SUPPLY
Mains operation
Check that the mains voltage on the type plate (on
the bottom of the device) corresponds to your local
mains supply. If this is not the case, contact your spe-
cialist dealer.
1 Plug the power adaptor into the socket
(100 - 240V
~
, 50/60 Hz).
Caution:
The device is connected to the mains with the
power plug. To fully disconnect the device from
the mains, pull out the plug.
The mains plug is used to disconnect the device. It
shall remain readily operable and should not be
obstructed during intended use.
Inserting the back-up battery
The back-up batteries ensure that the stored set¬tings
are not lost in the case of a power failure.
1 Open the battery compartment by pressing the
area market and pushing down the cover.
2 Observe the polarity marked on the base of the
battery compartment when inserting the batteries
(micro batteries, 2 x 1.5 V, R03/ UM 4/ AAA).
3 Close the battery compartment.
Note:
Remove the back-up battery when it is flat or when
you know that the device will not be used for a
long period of time.
Environmental note:
Batteries, including those which do not contain
heavy metal, should not be disposed of with
household waste. Always dispose of used batter-
ies in accordance with local environmental regu-
lations.
RADIO MODE
Antenna
For the best FM (UHF) reception it is sufficient to align
the wire antenna accordingly.
Switching on and off
1 Switching the device from standby with
»ON/OFF« button.
2 Switch the device to standby with »ON/OFF«
button.
Searching for and saving radio sta-
tions - automatically
You can store 10 radio stations on presets.
1 Activate the station search by pressing
»TUNING+/HR« or »TUNING-/MIN« buttons
until the frequency display changes to rapid run-
through.
The search stops when a station is found.
Note:
To move the frequency forward in steps, briefly
press »TUNING+/HR« or »TUNING-/MIN«
several times.
2 Press and hold the »PRESET« button to activate
the memory function.
3 Press »TUNING+/HR« or »TUNING-/MIN«
buttons to select the preset.
4 Press the »PRESET« button to save the station.
Note:
If the stations are already stored on the presets,
they are overwritten when new stations are stored.
5 To store more stations, repeat the steps 1 to 4.
Selecting stored stations
1 Select the preset by pressing the »PRESET« button
to select the preset stations one after another.
Adjusting the volume
1 Adjust the volume with »VOLUME -/AL 1« or
»VOLUME +/AL 2« buttons.
Setting the brightness of the display
1 Press the »SLEEP/SNOOZE/DIMMER« button
to adjust brightness levels in high, middle and low
levels.
TIMER MODE
Setting the time
1 Switching the device to standby with
»ON/OFF« button.
2 Press and hold the »TIME/MODE« button for
two seconds to activate the setting. The current
day of the week will be flashing on the LCD. »d1«
is Monday, and »d7« is Sunday.
3 Then press the »TIME/MODE« button again for
setting the current time.
4 Press »TUNING-/MIN« to set the minutes;
5 Press »TUNING+/HR« to set the hours;
6 Press the »TIME/MODE« button again to con-
firm the settings.
Setting the alarm time
1 Switch the device to standby with »ON/OFF« but-
ton;
2 Press and hold the »VOLUME -/AL 1« button
for alarm 1 or »VOLUME +/AL 2« for alarm 2;
3 For example, press and hold
»VOLUME -/AL 1« button to Then the alarm
days will be flashing on the LCD.
Activating and deactivating the alarm
1 In standby mode, press »VOLUME -/AL 1« or
»VOLUME +/AL 2« button to activate the alarm
with last used alarm settings.
2 For example, if pressed »VOLUME -/AL 1« but-
ton, the last used alarm time would be displayed;
3 By repeatedly pressing the »VOLUME -/AL 1«
button, the radio will display last set alarm time,
the » « and the » « icons.
Sleep timer
1 Press and hold the
»SLEEP/SNOOZE/DIMMER« button for about
2 seconds to activate the sleep timer.
2 Then repeatedly press the
»SLEEP/SNOOZE/DIMMER« button to select
the auto switch-off timer from 90 minutes to 10
minutes.
3 To switch off the sleep timer before the set time
press and hold »SLEEP/SNOOZE/DIMMER«
button for about 2 seconds, then repeatedly press
the button again until »OFF« is displayed.
4 Press the »TUNING-/MIN« or »TUNING+/
HR« buttons to adjust the alarm days.
5 Press the »VOLUME -/AL 1« button to confirm;
6 Press the »TUNING-/MIN« button to set the
alarm minutes;
7 Press the »TUNING+/HR« button to set the
alarm hours;
8 Press the »VOLUME -/AL 1« button to finish the
alarm 1 settings.
Note:
The device wakes you up at the set alarm time, the
alarm duration is 60 minutes.
Interrupting the alarm
Press the »SLEEP/SNOOZE/DIMMER« while
the alarm is sounding.
Note:
The alarm signal will be stopped, and the alarm
will be sounded again after nine minutes.
Cancelling the alarm
1 Press »ON/OFF« while the alarm is sounding.
Note:
The alarm will be sounded again at the next set
alarm time.
SETUP AND SAFETY EN
This device is designed for the
playback of audio signals. Any
other use is expressly prohibited.
Protect the device from moisture
(water drops or splashes). Do
not place any vessels such as
vases on the device. These may
be knocked over and spill fluid
on the electrical components,
thus presenting a safety risk.
Do not place any naked flames
such as candles on the device.
Thunderstorms are a danger to
all electrical devices. Even if the
device is switched off, it can be
damaged by a lightning strike to
the mains cable.
Charging a mobile phone
The USB socket on the back side can provide DC
power of 5V for charging a mobile phone. Connect
the mobile phone to the USB socket with an appro-
priate cable. The USB power is available in all the
operating modes and including standby mode. Refer
to the user manual or the manufacturer of the mobile
phone to verify if it supports charging from an USB
power. The USB socket is suitable for DC power-out
only and cannot be used for e.g. playback of music
from a USB stick.
The type plate is located on the
bottom of the device.
Do not expose the device to ex-
treme heat, caused for example
by direct sunlight, heator fire.
Compliance with the WEEE Directive
and Disposing of the Waste Product:
This product complies with EU WEEE Directive
(2012/19/EU). This product bears a classification
symbol for waste electrical and electronic equipment
(WEEE).
This product has been manufactured with
high quality parts and materials which
can be reused and are suitable for recy-
cling. Do not dispose of the waste product
with normal domestic and other wastes at
the end of its service life. Take it to the collection
center for the recycling of electrical and electronic
equipment. Please consult your local authorities to
learn about these collection centers.
TIME
TUNING+/HR VOL+/AL 2
VOL-/AL 1
TUNING-/MIN
ON/OFF
PRESET
USB
Always disconnect the mains
cable during a storm.
If malfunctions occur due to
static electricity charges or brief
mains voltage surges, reset the
device. To do this, pull out the
mains adapter and connect it
again after a few seconds.
Make sure the device is ade-
quately ventilated. Do not cover
the ventilation slots with newspa-
pers, table cloths, curtains, etc.
When deciding where to place
the device, please note that furni-
ture surfaces are covered by var-
ious types of varnish and plastic,
most of which contain chemical
additives.
SLEEP
SNOOZE
DIMMER
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Grundig Sonoclock 3000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Grundig Sonoclock 3000 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 0,34 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info