44
SPECIAL SETTINGS ------------------------------------------------------------------
Tuning analogue television stations
This setting is only necessary if you cannot receive any digital stations
and you have not carried out an analogue search during initial setup.
The television station can be set directly or using the search.
Switching the television to analogue channels
1Open the »INPUT SOURCE« menu by pressing » «.
2Select input source »ATV« with »q« or »w« and press »OK«to
confirm.
Note:
Additional operations are explained in the following sections.
Re-tuning all analogue television channels
These settings are only necessary if you can not receive any digital
stations or if you want to re-tune all analogue channels.
The analogue television stations are listed in the channel list after the
digital television stations.
Note:
Plug the rooftop antenna cable (for analogue television stations)
into the »ANT IN« socket on the television.
1Open the menu with »M«.
– The »PICTURE« menu appears.
2Select the »CHANNEL SETUP« menu with »r« or »e«.
3Select »Autotuning« with »q« or »w« and confirm with »G«.
4Select »Country Selection« by pressing »q« or »w« and press
»r« or »e« to make the setting.
5Select the »Scan Type« with »q«.
Press »r« or »e« to select the »ATV« display and start the search
with »G«.
– The »Searching...« menu appears, and the search for analogue
TV stations begins. This may take several minutes depending
on the number of television stations received.
Note:
You can stop the search by pressing »M«.
6Press »M« to end the setting.
CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module Not Inserted
Select Back
Exit
Active Antenna Power On
s
s
s
s
Searching...
14%... 161.25 MHz ATV
1 ARD
2 ZDF
3 BR3
4 3 SAT
Exit
GGGGGGGGGGGGGGGG
ATV
ATV
ATV
ATV
Skip
02Leemaxx 19_en:Layout 1 15.07.2009 10:28 Uhr Seite 44
