15
ENGLISH
SETTINGS
-----------------------------------------------------------------------------------------------------------------------------------------
Tuning the television channels
from satellite (DVB-S)
You have two options for tuning digital satellite
channels.
A The easy installation,
which pre-configures all antenna settings for
the satellite channels on Astra 19.2° East.
B The advanced installation
can be used if you wish to receive satellite
channels from various satellites. To do so,
you must make the antenna settings (Satel-
lite, LNB Power, LNB Type, DISEqC Mode,
LNB Selection) for the satellites chosen.
Easy installation
1 In the »Source Setup« menu, in the »Connec-
tion Type« line, select the option »Satellite«
with
»
B
« or »
A
«.
2 Select the line »Easy Installation« with
»
C
«
or
»
D
« and press »OK« to confirm.
– Other menu options will be displayed,
the satellite Astra 19.2° East is preset.
3 Start the scan with »O« (green).
– The »Search results« menu appears, and
the scan for TV channels begins.
– Depending on the number of television
channels received, this can easily take a
few minutes.
– The scan is complete as soon as the »PRO-
GRAM TABLE« appears.
Note:
7
You can abort the scan by pressing »M«.
Advanced installation
1 In the »Source Setup« menu, in the »Connec-
tion Type« line, select the option »Satellite«
with
»
B
« or »
A
«.
2 Select the line »Advanced Installation« with
»
C
« or »
D
« and press »OK« to confirm.
– The menu appears.
Satellite
ASTRA*2A,2B
Frequency*(MHz)
10714
LNB*Type
22*kHz*
Universal
Auto
DISEqC*Mode
Off
LNB*Power*
Off
LNB*Selection
1/4
Auto*Tuning
Manual*Tuning
Quality
Signal*strength
Low************Normal*************Good
Exit
Back
INSTALLATION
ANTENNA*SETTINGS
3 Select the line »Satellite« with »
C
« or »
D
«
and press »OK« to confirm.
– The »SELECT SATELLITE« menu appears.
Select the satellites with
»
C
«, »
D
«, »
B
« or
»
A
« and press »OK« to confirm.
Note:
7
The setting in the line »Transponder« is not
required for this automatic scan.
4 Select the line »LNB Power« with
»
C
« or
»
D
«.
Depending on the type of LNB, set the LNB
power supply to »13/18 V« or »14/19 V«
with
»
B
« or »
A
«.
5 Select the line »LNB Type« with
»
C
« or »
D
«
and press »OK« to confirm.
Select the type of LNB installed with
»
B
« or
»
A
«.
Save the selection with »
O
« (green) or abort
the action with »
O
« (red).
