37
1. For ease of installation, extend
LATCH to its maximum length
and remove from storage bars.
2. Position base in vehicle seat as
shown.
3. Make sure LATCH is through
vehicle/LATCH belt path normally
used for vehicle seat belt.
.
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached .
5. Tighten LATCH by pushing down
hard on base and pulling the
adjustment belt .
6. NEVER put two LATCH connectors
on one vehicle LATCH anchor unless
specifically allowed by the vehicle
manufacturer
.
7. Test infant restraint for secure
installation as described in infant
restraint
“Final Safety Check” page.40
.
8. Check that the LATCH stays tight
and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Graco at 1-800-345-4109.
7.3 Using LATCH to install Base