590652
10
Verklein
Vergroot
Pagina terug
1/14
Pagina verder
10 GMC-I Messtechnik GmbH
5 Maintenance – Recalibration
5.1 Housing
No special maintenance is required for the housing. Keep outside
surfaces clean. Use a slightly dampened cloth for cleaning. Avoid the
use of cleansers, abrasives and solvents.
5.2 Batteries
Check the batteries at short regular intervals to makes sure no
leakage has occurred. If leakage occurs, electrolyte must be fully
removed from the instrument and new batteries must be installed.
Remove the batteries from the battery compartment if the measuring
instrument will not be used for a lengthy period of time. Refer to
chapter 3.2 regarding battery replacement
Attention: If the LED lights up red before or during measurement, the
batteries must be replaced immediately.
Use only recommended battery types (see chapter 3.2).
5.2.1 Details on Power Consumption and Operating Time
Low-Resistance Measurement
The instrument draws the most power from the batteries when the
value of the contact resistance is the lowest.
Power consumption does not exceed the value of 0.4 A.
Insulation Resistance Measurement
Power consumption from the batteries depends on the selected test
voltage and the actual value of the insulation resistance, i.e. on the
load imposed on the source of the measuring voltage U
N.
The table
below specifies the power consumption from the batteries for the
indicated parameters.
The following table lists the number of possible measurements with
one set of alcaline batteries by taking into account the power con-
sumption from the batteries.
The number of possible measurements depends on the following conditions:
one measurement takes 1 minute
the insulation resistance complies with the requirements of the
standard
(power consumption from the battery in accordance with
column 3 of the table above).
5.3 Replacing the Fuse
The low-resistance measuring range is protected with a fuse, see
chapter 6. The fuse blows if a voltage is applied to the test probes
which may cause damage to the instrument as a result of its
magnitude or polarity.
Adhere to the prescribed sequence when replacing the fuse:
Ð Remove the test probes from the device under test.
Ð Loosen the 3 screws in the housing base.
Test Voltage
U
N
R
X
measured at I
BAT
(U
BAT
= 6 V)
(*if LED lights up green, pointer oscillates and there is no acoustic signal,
the transformer is overloaded)
500 V 0 kΩ / < 1 A * 0.1 MΩ / < 1.1 A > 1 MΩ / < 0.6 A
> 400 M
Ω
/ < 0.3 A
250 V 0 kΩ / < 1 A * 0.1 MΩ / < 0.4 A
> 500 k
Ω
/ < 0.4 A > 400 M
Ω
/ < 0.2 A
100 V 0 kΩ / < 1 A * 0.1 MΩ / < 0.2 A
> 200 k
Ω
/ < 0.3 A > 400 M
Ω
/ < 0.2 A
Test Voltage U
N
AlMn Battery min. 2300 mAh
500 V > 300 measurements
250 V > 500 measurements
100 V > 750 measurements
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gossen Metrawatt METRISO 5024 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gossen Metrawatt METRISO 5024 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info