15
• Switch the appliance off and unplug
it before detaching any accessory.
• Never immerse the motor unit in
water or any other liquid, nor rinse it
under the tap.
• Never use your fingers or an
object (e.g. a spatula) to push
ingredients into the cutter housing
while the appliance is running. Only
the pusher is to be used for this
purpose.
• Be very careful when handling the
cutter unit, especially when
removing it from the worm shaft and
during cleaning. The cutting edges
are very sharp!
• Never use any accessories or parts
from other manufacturers or that
have not been specifically
advised by Gorenje, d.d.. Your
guarantee will become invalid if such
accessories or parts have been
used.
• Thoroughly clean the parts that will
come into contact with food before
you use the appliance for the first
time.
• Do not clean the metal parts in the
dishwasher, as dishwasher
detergents will cause these parts to
darken or oxidize. See the Cleaning
section for instructions on how to
clean the various parts.
• This appliance is meant for
household use only.
• Never connect this appliance to an
external timer switch or remote
control system in order to avoid a
hazardous situation.
This appliance is marked according to the
European directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE).
This guideline is the frame of a European-wide
validity of return and recycling on Waste
Electrical and Electronic Equipment.
Safety system
This appliance is equipped with a non-
resettable, current-sensitive glass fuse that cuts
off the power supply in case of motor failure to
prevent overheating of the appliance.
This system will automatically cut off the power
supply to the appliance in case of overheating.
If your appliance suddenly stops running:
1. Pull the mains plug out of the socket.
2. Let the appliance cool down for 60 minutes
3. Put the mains plug in the socket.
4. Press the switch button to turn off the
appliance.
5. Press the circuit breaker button at the
bottom of the appliance to turn on the
appliance.
Please contact you dealer of an authorized
service center if the thermostat system is
activated too often.
Mincing meat - tips and warnings
• Make sure the cutting edges of the cutter unit
are pointing outwards.
• Make sure the notch of the grinding disc
fits onto the projection of the cutter housing.
• Never use frozen meat!
• Do not overload the appliance during use by
pushing too much meat into the cutter
housing.
• Cut the meat into 10cm-long, 2cm-thick strips.
• Remove bones, gristles and sinews as much
as possible.
• Put the prepared meat on the feeding tray.
• Press the on/off button to switch the appliance
on.
• Use the pusher to gently push the meat into
the cutter housing.
• For steak tartare, mince the meat with the
medium grinding disc twice.
