Handleiding Gorenje DQG8530 (pagina 23 van 32) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans)

603622

Verklein

Vergroot

Pagina terug

1/32

Pagina verder

carbon lter both require special attention.

•Theanti-greaselter is responsible retaining the grease

particles suspended in the air, therefore it is subject to

clogging with variable frequency according to the use of the

appliance.

- To prevent the danger of possible res, at least every 2

months one must wash the anti-grease lters by hand using

non-abrasive neutral liquid detergents or in the dishwasher

at low temperatures and on short cycles.

- After a few washes, colour alterations may occur. This does

not give the right to claim their replacement.

•Theactivecarbonlters are used to purify the air that is

sent back into the room and its function s to mitigate the

unpleasant odours produced by cooking.

- The non-regenerable active carbon lters must be replaced

at least every 4 months. The saturation of the active charcoal

depends on the more or less prolonged use of the appliance,

on the type of kitchen and on the frequency with which anti-

grease lter is cleaned.

- Regenerable active charcoal lters must be washed by hand,

with non abrasive neutral detergents, or in the dishwasher at

a maximum temperature of 65°C (the washing cycle must be

complete without dishware). Remove excess water without

damaging the lter, remove the plastic parts, and let the mat

dry in the oven for at least 15 minutes approximately at a

maximum temperature of 100°C. To keep the regenerable

charcoal lter functioning ecient this operation must be

repeated every 2 months. These must be replaced at least

every 3 years or when the mat is damaged.

•Beforeremountingtheanti-greasefiltersandthe

regenerable active charcoal lters it is important that they

are completely dry.

•Clean the hood frequently, bothinternally and

externally,usingaclothdampenedwithdenatured

alcohol or neutral liquid detergents that are non abrasive.

•  The lighting .system is designed for use during cooking

and not for the prolonged general lighting of the room. The

prolonged use of the lighting system signicantly decreases

the average duration of the bulbs.

•  If the appliance is equipped with courtesy lights it is possible

to use them for general room lighting for a prolonged amount

of time.

•Attention: The non compliance with the hood cleaning

warnings and with the replacement and cleaning of the lters

entails risk of res. One therefore recommends keeping to the

suggested instructions.

•Replacinghalogenlightbulbs(Fig.16.1):

To replace the halogen light bulbs B, remove the glass pane

C using a lever action on the relevant cracks.

Replace the bulbs with new ones of the same type.

Caution: Do not touch the light bulb with bare hands.

•ReplacingLEDlamps(Fig.16.2):

If the appliance version is with LED lamps, the intervention of

a specialised technician is necessary to replace them.

•Commands(Fig.17):

NOTE: With this control it is possible to manage the appliance

also with a remote control to be requested as accessory.

Power Button (A) = the on / o button switches on and o

the whole hood (motor and lights).

By pressing the button the motor starts at 1st speed.

Fan Speed button (B) = From the OFF position, press once

for the 1st speed, twice for the 2nd speed and three times

for the 3rd speed. In order to activate the intensive speed,

press the button for 5 seconds regardless of the status of the

hood. For each speed only the led indicating the set speed

will turn on. The intensive speed is indicated by the ashing

of the led indicating speed 3. The duration of the intensive

speed is 10 minutes; after this time the hood goes back to

the last set speed.

In order to remove the intensive speed press the power button

and the hood will switch o, or press the Fan speed button

and the speed goes back to the previously set one. Speed of

the hood with cyclic trend.

Light button (C)= There are three light levels: High, medium,

low.

From the o position press once for the high level, twice for

the medium level, three times for the low level and four times

to turn the lights o.

The level of the lights has a cyclic trend: High, medium,

low, o.

Timer button (D) = With any type of speed (excluding the

intensive speed), by pressing the button, the timer function

is activated for 15 minutes. After this time has elapsed the

hood will turn o (motor and any light on).

Lights indicator (E) = The lights indicator will switch on when

the lights are on at any level.

Filters indicator (F) = After 30 minutes of operation, the led

of the lters indicator will switch on, not ashing indicating

that the anti-grease lters have to be washed. To reset the

function (with the hood o), press the Fan speed button for

5 seconds. After this operation, the led of the lters indicator

turns o and the setting of the 30 hours starts again from

the beginning.

After 120 hours the led will ash continuously. This means

that the carbon lters have to be replaced (if present). To reset

the function (with hood o) press the Fan speed button for 5

seconds. After this operation, the led of the indicator turns o

and the setting starts again from the beginning.

Clean air indicator (G) = With the hood o, press the Power

button (A) for 5 seconds to activate the clean air function. This

will switch on the motor at speed 1 for 10 minutes every hour.

The light indicator will switch on without ashing and the led

of the 1st speed will switch on. In the remaining 50 minutes

the light indicator will ash. The function can be deactivated

by pressing any button except for the lights one.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY

FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE

ABOVE WARNINGS.

- 23 -

Gorenje DQG8530 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info