Handleiding Gorenje DKG9335E (pagina 7 van 60) (Alle talen)

603310

Verklein

Vergroot

Pagina terug

1/60

Pagina verder

- 7 -

• We recommend the use of an air exhaust pipe with a

diameter of 150. If a pipe with a smaller diameter is used,

the efficiency of the product may be reduced and its

operation may become noisier

• FIXING TO THE WALL

Drill the holes A respecting the distances indicated

(Fig.2). Fix the appliance to the wall and align it in

horizontal position to the wall units. When the appliance

has been adjusted, definitely fix the hood using the

screws A (Fig.5). For the various installations use screws

and screw anchors suited to the type of wall (e.g.

reinforced concrete, plasterboard, etc.). If the screws and

screw anchors are provided with the product, check that

they are suitable for the type of wall on which the hood is

to be fixed.

• FIXING THE DECORATIVE TELESCOPIC FLUE

Arrange the electrical power supply within the dimen-

sions of the decorative flue. If your appliance is to be

installed in the ducting version or in the version with

external motor, prepare the air exhaust opening. Adjust

the width of the support bracket of the upper flue (Fig.3).

Then fix it to the ceiling using the screws A (Fig.3) in

such a way that it is in line with your hood and respecting

the distance from the ceiling indicated in Fig.2. Connect

the flange C to the air exhaust hole using a connection

pipe (Fig.5).

Insert the upper flue into the lower flue. Fix the lower

flue to the hood using the screws B provided (Fig.5),

extract the upper flue up to the bracket and fix it with the

screws B (Fig.3). If your appliance has the lower

connections indicated as in Fig. 4 A, the fixing to be

carried out is that shown in Fig. 6 A

To transform the hood from a ducting version into a

filtering version, ask your dealer for the charcoal filters

and follow the installation instructions.

• FILTERING VERSION

Install the hood and the two flues as described in the

paragraph for installation of the hood in ducting version.

To assemble the filtering flue refer to the instructions con-

tained in the kit. If the kit is not provided, order it from

your dealer as accessory. The charcoal filters must be

fitted in the ducting unit located inside the hood (Fig.9-

10).

USE AND MAINTENANCE

• We recommend that the cooker hood is switched on

before any food is cooked. We also recommend that the

appliance is left running for 15 minutes after the food is

cooked, in order to thoroughly eliminate all contaminated

air.

The effective performance of the cooker hood depends

on constant maintenance; the anti-grease filter and the

active carbon filter both require special attention.

• The anti-grease filter is used to trap any grease particles

suspended in the air, therefore is subject to saturation

(the time it takes for the filter to become saturated

depends on the way in which the appliance is used).

The acrylic filter, which is found resting on the grille,

should be replaced when the text, visible through the

grille, changes colour and the ink spreads; the new filter

should be fitted in such a way that the text can be seen

through the grille from outside the cooker hood.

If the filters do not have any text on them, or if metal

filters or aluminium panel filters are used, they should

be washed every 2 months in order to prevent the risk of

fire. To wash the filters, proceed as follows:

- Remove the filter from the grille and wash it using a

solution of water and neutral liquid detergent, leaving

the dirt to soften.

- Rinse thoroughly with warm water and leave to dry.

The metal filters and/or aluminium panel are also

dishwasher safe. If the filters are made using aluminium,

or if an aluminium panel is used, after a few washes the

colour may change. This does not mean they have to be

replaced.

If the replacement and washing instructions are not

followed, the anti-grease filters may present a fire hazard.

• The active carbon filters are used to purify the air which

is released back into the room. The filters are not

washable or re-usable and must be replaced at least once

every four months. The active carbon filter saturation level

depends on the frequency with which the appliance is

used, the type of cooking performed and the regularity

with which the anti-grease filters are cleaned.

• Remove build-up from the fan and other surfaces of

the cooker hood regularly using a cloth moistened with

denatured alcohol or non-abrasive neutral liquid

detergent.

• The light on the cooker hood is designed for use during

cooking and not for general room illumination. Extended

use of the light reduces the average duration of the bulb.

• Replacing halogen light bulbs (Fig. 7).

To replace the halogen light bulbs B, remove the glass

pane C using a lever action on the relevant cracks.

Replace the bulbs with new ones of the same type.

Caution: do not touch the light bulb with bare hands.

COMMANDS: (Fig.14)

Push-button A = on/off lights switch

Push-button B = on/off cooker hood switch. The appli-

ance switches on at speed level 1, If the cooker hood is

on depress the push-button for 2 sec. to switch off the

cooker hood. If the cooker hood is at speed level 1 it will

not be necessary to depress the push-button to switch

the cooker hood off. Decreases the motor speed.

Display C = indicates the motor speed level selected

and activates the timer.

Push-button D = switches on the cooker hood. In-

creases the motor speed. Touching the key at 3rd speed,

the intensive function runs for 10', then the appliance go

back to work at the original speed. During this function

the display blinks.

Key E = The Timer times the functions on activation for

15 minutes, after which they are switched off. The Timer

is deactivated by re-pressing Key E. When the Timer is

activated the decimal point must flash on the display.

The Timer cannot be activated if the intensive speed is

functioning.

The “clean air” function is activated by pressing key E

for 2 seconds when the appliance is switched off. This

switches the motor on for 10 minutes every hour at the

first speed. During functioning a rotary movement of the

Gorenje DKG9335E Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info