GM Electronics Ltd.
Golden Mask Deep Hunter pro2 – Instruction Manual
3. Set the value of the desired sensitivity of the device (depth of detection) with
potentiometer "SENSITIVITY" (larger values provide high sensitivity).
The values that are selected depend on the nature of the environment in which
will be done searching - in "light" soil can be initiated with values around "7"
÷ "9"; in "heavier" soil it is better to choose the value "5" or less in the scale of
the potentiometer. Subsequently, this value can be increased to the maximum
possible for the conditions.
4. The potentiometer "GROUND Man/AUTO" is set to "7".
5. Turn the "VOLLUME On/Off" in a clockwise direction to be switched
“On” the detector and set the level of the volume. Values around "6" ÷ "8" on
the scale of the potentiometer are usually sufficient for the job.
6. Turn "GROUND Man/AUTO" in the direction counterclockwise to the
emergence of sound - "hum" or "pop" (setup known as "threshold").
Achieving such a setup is very important for a successful operation and
maximize the potential of the detector.
7. Lift the antenna above ground surface to the height at which it will be used
during the search (about 10 cm).
If after lifting the antenna needle on the meter "SIGNAL" deviate to the left of
the position "0", this means that under the antenna was metallic object and the
initial setting is not performed correctly. Move the antenna to another location
and repeat actions 1 to 7.
8. Press and relies button "RETUNE".
