12
Assembly of carrying strap PRO 8
G Fig. E
Operation
G Remove the pump by turning it to
the left. Before doing this release
pump rods, turn them 180° and
transmit the srew force via the back
of the zwistlocks on the pump hous-
ing.
G Filling of the container. Attention!
Max. liquid capacity (see technical
data) and the correct dosage of the
chemicals manufacturer have to be
observed.
G Re-insert pump and tighten.
G Operate pump until a working pres-
sure of 3 bars is reached.
The maximum operating has been
reached in the case of units without
a pressure gauge when the built-in
safety valve audibly begins to blow
off.
G For spraying press down the opera-
tion lever at the valve body. When
releasing the lever the output will be
interrupted.
Emptying and
Service
G Any residual pressure in the tank
can be vented by lifting up the knob
on the safety valve (only for PRO 5/8
spray units). In the case of the
STRATOS 5 unit, the pressure is re-
leased by the quick-action valve
when the handle is operated. If there
is still some of the spraying liquid in-
side the tank, turn the unit upside
down and then press the handle.
G The pomp will be carefully, at first
only a few turns by lefthand rotation
screwed off, so that the compressed
air being still in the tank can deflate.
G After use clear apparatus carefully
and dry it in open state.
G The working life will be extended
when greasing the washers and col-
lars sometimes. Only use resin- and
acid-free grease.
G For easy cleaning and safe neu-
tralization of remaining
liquid is recommended to use
GLORIA special powder,
art.-no. 263.0000.
G Important! Above-average use due
to manner of operating (including
the tranport to the place of operation
and the storage when not using the
sprayer), influences of the surround
