11
Customer ServiceTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions
Electrical ground is required on this compactor.
DO NOT ground to a gas pipe.
DO NOT change the power supply cord plug. If it
does not fit the outlet, have a proper outlet installed
by a qualified electrician.
DO NOT have a fuse in the neutral or grounding
circuit. A fuse in the neutral or grounding circuit
could result in an electrical shock.
DO NOT use an extension cord with this compactor.
Check with a qualified electrician if you are not
sure the compactor is properly grounded.
Failure to follow these instructions could result in
death or serious injury.
WARNING
Electrical Shock
Hazard
If codes permit and a separate grounding wire is used, it is recommended that a qualified
electrician determine that the grounding path is adequate.
IMPORTANT: Observe all governing codes and ordinances.
A 120-volt, 60-Hz, AC-only, 15- or 20-ampere, fused electrical supply is required. Time-delay fuse
or circuit breaker is recommended. It is recommended that a separate circuit serving only this
appliance be provided.
Recommended Grounding Method
For your personal safety, this appliance must be
grounded. This appliance is equipped with a power
supply cord having a 3-prong grounding plug. To
minimize possible shock hazard, the cord must be
plugged into a mating, 3-prong, grounding-type,
wall receptacle, grounded in accordance with the
national Electrical Code ANSI/NFPA70—latest
edition* and all local codes and ordinances. If a
mating wall receptacle is not available, it is the
personal responsibility and obligation of the
customer to have a properly grounded, 3-prong,
wall receptacle installed by a qualified electrician.
Copies of the standards listed may be
obtained from:
*National Fire Protection Association
Batterymarch Park,
Quincy, Massachusetts 02269
3-prong grounding-type wall receptacle
3-prong grounding plug
Grounding
plug
Power supply cord
