■ To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
■ The remote control signal has a range of up
to 21 feet.
■ Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
■ Make sure batteries are fresh and installed
correctly–see the
Care and Cleaning
section.
Customer ServiceTroubleshooting Tips
Operating InstructionsSafety Instructions Installation Instructions
About the controls on the air conditioner–models with touch pads.
Features and appearance will vary.
5
Air Conditioner Controls
Remote Control
Controls
ON/OFF Pad
Turns air conditioner on and off.
Display
Shows the set temperature or time remaining
on timer.
MODE
Use to set the air conditioner to
COOL
or
FAN
mode.
Increase
▲
/Decrease
▼
Pads
Use to set temperature when in
COOL
mode or
to set the time when using the timer feature.
FAN Pad
Use to set the fan speed at
LOW, MED
or
HIGH
.
CIRCULAIRE Pad
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn
ON
until the desired air direction is obtained,
then turn it
OFF
.
ENERGY SAVER Pad
Controls the fan.
ON–
The fan and compressor cycle on and off.
This results in wider variations of room
temperature and humidity. Normally
used when the room is unoccupied.
Note: The fan will continue to run for a short
time after the compressor cycles off.
OFF–
The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at
OFF
in order to use the fan
settings (on the mode control).
TIMER Pad
Turn on and use the
INCREASE
▲
/
DECREASE
▼ pads to set the number of hours
you want the air conditioner to run before
turning off automatically. You can set the
timer to run for up to 24 hours. To cancel the
timer, press the
TIMER
pad until the display
time disappears.
Remote Control Signal Receiver
Remote Control
