6
Customer Service Troubleshooting Tips Operating Instructions Safety InstructionsInstallation InstructionsCustomer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips Installation Instructions Safety Instructions
Operating Instructions
About the controls on the air conditioner–models with touch pads.
When the air conditioner is turned on, it will
automatically start in the setting last used.
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
Vent Control
The vent control is located above the control knobs.
When set at
CLOSE
, only the air inside the room will
be circulated and conditioned. When set at
OPEN
,
some inside air is exhausted outside.
To open the vent, push the lever to the right.
To close it, push it to the left.
COOL Mode
Use the
COOL
mode with
HIGH, MED
or
LOW
fan for
cooling. Use the
INCREASE
▲
/ DECREASE
▼ pads to
set the desired temperature between 64°F and 86°F
in 2°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
in a cool setting, it will take approximately 3 minutes for
the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling–
Select the
COOL
mode and
HIGH
or
MED
fan with a middle set temperature.
For Maximum Cooling–
Select the
COOL
mode and
HIGH
fan with a lower set temperature.
For Quieter & Nighttime Cooling–
Select the
COOL
mode and
LOW
fan with a middle set temperature.
NOTE: If you switch from a COOL setting to OFF or to a
fan setting, wait at least 3 minutes before switching
back to a COOL setting.
Air Direction – Up and Down
Fingertip pressure on the horizontal louvers adjusts
the air direction up or down.
FAN Mode
Use the
FAN
at
HIGH, MED,
or
LOW
to provide air
circulation and filtering without cooling. Since fan
only settings do not provide cooling, a temperature
setting will not be displayed.
