20
UK
USE
• Place the appliance on a flat and dry
surface.
• Apply downward pressure onto the ap-
pliance so that the suction feet (6) get a
good grip.
• Position the appliance so that you can op-
erate the on/off button with your left hand
and the sliding table with your right hand.
Plug the appliance into the mains.
• Pull the food shield (13) backward, as far
as it can slide.
• Push the sliding table (8) back and forth
a few times on the rail to ensure that it
moves correctly.
• Place the food to be sliced on the sliding
table. If the food is too large for the appli-
ance, cut it into suitable pieces first. Put
the food holder (14) onto the food guide
handle (10) and adjust it until it holds the
food firmly in place.
• Place the tray (9) behind the blade to col-
lect the slices.
• Use the dial (11) to select the required
slice thickness from 0-20 mm.
• Switch on the appliance using the on/off
button (2). The blade starts rotating.
• Move the sliding table back and forth to
slice the food. Always keep your right
thumb on the right side of the piece holder
(10) to avoid any contact with the blade.
• Always switch the appliance off using the
on/off button when you have finished using
it.
TIP
• To slice meats wafer thin, chill thoroughly
for 2-4 hours in freezer before slicing.
• When slicing warm boneless roasts, re-
move from oven and allow to stand for 15
to 20 minutes before slicing.
• Cold cuts keep longer and retain flavour if
sliced as required.
• Foods with an uneven texture – like fish
and thin steaks – are often difficult to slice.
• The appliance can also slice e.g. carrots
or potatoes in thin slices for chips.
CLEANING
• Always switch the appliance off at the wall
socket and unplug before cleaning.
• Unless clearly specified in the cleaning in-
structions below, please note that none of
the parts of this appliance are dishwasher
safe.
• Wash all removable parts in warm water
with a little detergent.
• Pull the food guide (10) backward, as far
as it can slide.
• Turn the finger screw (3) holding the blade
in place clockwise, remove it and carefully
lift off the blade. Clean the blade thorough-
ly in warm soapy water. Dry the blade with
a tea towel or similar. Do not let the blade
air dry.
• Clean the piece holder thoroughly in warm
soapy water. Dry the piece holder with a
tea towel or similar.
• Wipe the sliding feed table (8), the food
guide handle (10) and the food shield (13)
with a well-wrung cloth and some deter-
gent.
• Do not wash the motor unit. Wipe the mo-
tor unit with a damp cloth.
• Never use abrasive detergents or sol-
vents.
• Reassemble the appliance.
Please note: The finger screw (3) must
be turned counterclockwise to secure the
blade.
• Store the appliance in a dry and dust-free
location.
