- the tension of the saw chain,
- the oil level,
Wear suitable protective clothing.
Adjust the working length (using the telescoping pole).
Put on the shoulder strap.
Check you are standing safely and check your working surround-
ings.
There is no need to force the pole saw into the cut. Run the motor and
only lightly press on the tool. If the saw jams in the cut, do not try and
pull the tool out by force.
Cutting Branches – Cutting thick Branches on a Tree
When cutting off larger branches, you
should first cut into the branch from
below. First cut into the branch from
below outside the place where you intend
to cut off the branch. The cut should go
from one third to halfway through the
branch (step 1). This prevents the branch
from buckling when you cut into the
branch from the top outside the first cut
(step 2).
Finally, cut off the stump with one clean
cut (step 3).
Before you start cutting, attach the
branch at the limit stop of the saw.
Maintenance of the Pole Saw
ATTENTION! First disconnect to motor unit from power mains before
undertaking maintenance.
Always wear gloves while maintaining or cleaning the unit.
