584001
50
Verklein
Vergroot
Pagina terug
1/124
Pagina verder
Page 4-14 400 SERIES INSTALLATION MANUAL
Page Rev L P/N 190-00140-02
4.7 COM/VOR/ILS AUDIO (GNC 420 AND GNS 430 ONLY)
4.7.1 COM/VOR/ILS Audio Function and Emergency Mode
Activation of COM MIC KEY enables COM MIC AUDIO and causes the transceiver to transmit.
500 COM AUDIO and 500 VOR/ILS AUDIO are 100 mW audio outputs that are intended to drive a
headset or an audio panel.
Momentarily depressing the COM REMOTE TRANSFER button toggles the active and standby COM
frequencies. Momentarily depressing the VLOC REMOTE TRANSFER button toggles the active and
standby VLOC frequencies.
The COM REMOTE TRANSFER input may be used for EMERGENCY operation of the COM
transmitter. If the remote transfer switch is depressed for two seconds, the active COM frequency changes
to 121.50 MHz. Once the emergency frequency is activated through COM REMOTE TRANSFER, GNS
430 and GNC 420 COM transceivers with Mod 2 incorporated ignores inputs from the front panel controls
for COM selections only. The pilot may exit this independent mode—restoring COM selection control to
the front panel knobs and buttons—by momentarily depressing the COM REMOTE TRANSFER switch.
When TRANSMIT INTERLOCK is active, the GNC 420 or GNS 430 COM receiver sensitivity is
decreased. This input is intended to reduce interference from other transmitters in the aircraft. The
TRANSMIT INTERLOCK input should be connected to the PTT input of other transmitters in the aircraft.
If connected to multiple PTT inputs, these connections must include diode isolation or multiple radios
transmit simultaneously.
4.7.2 COM/VOR/ILS Audio Electrical Characteristics
4.7.2.1 COM MIC KEY
Pin Name Connector Pin I/O
COM MIC KEY P4002 4 In
This input is considered active if either the voltage to ground is < 1.9 V or the resistance to ground
is< 375 . This input is considered inactive if the voltage to ground is 11-33 V
DC
.
4.7.2.2 COM MIC AUDIO, INTERCOM MIC AUDIO
Pin Name Connector Pin I/O
COM MIC AUDIO HI P4002 6 In
COM MIC AUDIO LO P4002 18 In
INTERCOM MIC HI P4002 5 In
INTERCOM MIC LO P4002 17 In
COM MIC AUDIO and INTERCOM MIC each have a 520 AC input impedance and supply the
microphone with a 9 V bias through 620 .
COM MIC AUDIO is set in the factory for 275 mV
RMS
to modulate the transmitter at 80% nominally. The
microphone gain adjustment is accessible through the top cover.
When a 125 mV
RMS
signal at 1000 Hz is applied to the INTERCOM MIC input, the level on the COM
AUDIO output is not less than 7.07 V
RMS
.
50

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin GNS 430 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin GNS 430 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,43 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info