724631
12
Verklein
Vergroot
Pagina terug
1/21
Pagina verder
1100W Garden Pump
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. XKJ-1109PE • 1/2019 • 44268
(toll free)
AFTER SALES SUPPORT
(toll free)
1100W Garden Pump
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL: №. XKJ-1109PE • 1/2019 • 44268
20 21
Connecting to the intake port (6) (Where water is to be
transferred from)
The Intake connection is to be connected to your
water supply via various connections (not supplied).
An example set up is shown here (Fig Q).
The intake port (6) of the pump is 1” BSP.  So to
purchases of any ttings for the intake port (6) of
the pump, the threaded tting is required to be
1” BSP. This is shown as number 6 on page 8.
For the intake port (6), purchased ttings can be
used directly into the intake port (6) of the pump.
The tting supplied which is not being used on the pressure outlet (5) can
be used on the intake port (6) if required, however it is critical one of the
supplied ttings is used into the pressure outlet (5) of the pump.
Extra ttings can also be purchased from our online spare parts store.
Description NOTE: Teon tape (not supplied) is applied to all ttings
requiring tape for correct assembly.
Connecting the intake hose / suction pipe.
1. Screw an intake hose* minimum of 19mm (3/4”) diameter hose preferably
spiral re-inforced. This may be directly, or with a threaded nipple to the
pumps intake port (6) (25 mm (R1) (1” BSP)).
2. The intake hose* should rise from the water pick-up point up to the
pump. Always avoid laying the intake line higher than the pump as
this will cause air bubbles in the intake line which will delay and hinder
suction (Refer previous Fig C).
3. The intake and pressure lines* must be attached in such a way that they
do not place the pump under any mechanical strain.
4. If the intake line* is not air-tight the intake of air will hinder the intake
of water.
Purchased components for plumbed inlet: 
Figures R & S show the components for the plumbed threaded inlet
for a non pressure connection.
The tting supplied which is not being used on the pressure outlet (5) can be
used on the intake port
(6) if required, HOWEVER,
it is critical one of the
supplied adaptor ttings
(10 & 11) is used into the
pressure outlet of the
pump (5).
Preparing your pump for operation for the rst use.
NOTE: Ensure the unit is NOT connected to the mains power when
undertaking this task (Fig A).
NOTE: During the priming process if your pump is connected to a tap, ensure
the tap is open (Fig T).
Once the preparation of the pump is complete, you are ready to prime the
pump.
Preparing to prime your Garden Pump
The objective/process of priming your pump is to remove air from the system.
1. Set up the pump on at and rm ground (refer Fig C).
2. Using the spanner (8), unscrew the clear water ller cap (1) (Fig U) and
remove the coarse lter (2) together with the non-return valve (3) (Fig V/W).
NOTE: If the lter and
non-return valve does
not lift out of the pump,
remove the water intake
screw (7) (Fig X) and
gently push the non
return valve (3) upward
using the end of the
supplied spanner (8)
(Fig Y).
Q.
R. S.
T. U.
LOOSEN
OPEN
CLOSE
TIGHTEN
* Additional ttings are NOT supplied with this garden pump.
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gardenline XKJ1109 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gardenline XKJ1109 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,07 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info