Message Cause Action
Charging station
blocked
The contact between the charging plates on
the product and the contact plates on the
charging station is not good. The product has
made a number of tries to charge.
Put the product in the charging station and
make sure that the charging plates and con-
tact plates are connected.
An object prevents the product to enter the
charging station.
Remove the object.
The charging station is tilted or bent. Put the baseplate on level ground.
The guide wire is not installed correctly. Install the guide wire correctly. Refer to
To
install the guide wire on page 20
.
Stuck in charging sta-
tion
An object prevents the product to move out
from the charging station.
Remove the object.
Upside down
The product is in an incorrect position, the
product is tilting too much or is upside down.
Put the product in the correct position.
Needs manual charg-
ing
The product is set to the
Secondary area
op-
erating mode.
Put the product in the charging station.
Next start hh:mm
The schedule setting prevents the product
from operating.
Change the schedule settings. Refer to
To
do the schedule settings on page 23
.
The product has operated the maximum cut-
ting time for the day.
Usual operation of the product.
The time or date in the product is not correct. Set the time or date. Refer to
To set the time
& date on page 28
.
Today's mowing
completed
The product has operated the maximum cut-
ting time for the day.
Usual operation of the product. Refer to
Make an estimate of the necessary operating
time on page 24
.
Lifted
The lift sensor has been enabled because
the product has been lifted.
Make sure that the product body can move
freely around its body. Remove or create an
island around objects that can cause the
product body to be lifted. If the problem stays
speak to your authorized service technician.
Wheel drive problem,
right/left
Grass or other object around the drive wheel. Clean the wheels and around the wheels.
Electronic problem
Temporary electronic or firmware related
problem in the product.
Restart the product. If the problem stays
speak to your authorized service technician.
Loop sensor prob-
lem, front/rear
Tilt sensor problem
Temporary problem
Invalid sub-device
combination
Temporary battery
problem
Safety function faulty
Charging system
problem
Incorrect type of battery. Use original batteries recommended by the
manufacturer.
40 - Troubleshooting 1298 - 015 - 20.08.2021
