687465
43
Verklein
Vergroot
Pagina terug
1/56
Pagina verder
6 Troubleshooting
6.1 Introduction - troubleshooting
In this chapter, a number of messages are listed which may be shown in the display if there is a malfunction. There is
a proposal as to the cause and steps to take for each message. This chapter also presents some symptoms that can
guide you if the robotic lawnmower does not work as expected. More suggestions for steps to take in the event of
malfunction or symptoms can be found on www.gardena.com.
6.2 Fault messages
Below a number of fault messages are listed which may be shown in the display of the robotic lawnmower. Contact
your local GARDENA representative if the same message appears often.
Message Cause Action
Wheel motor blocked,
left
Grass or other object has wrapped around
the drive wheel.
Check the drive wheel and remove the grass
or other object.
Wheel motor blocked,
right
Grass or other object has wrapped around
the drive wheel.
Check the drive wheel and remove the grass
or other object.
Cutting system
blocked
Grass or other object has wrapped around
the blade disc.
Check the drive wheel and remove the grass
or other object.
The blade disc lies in a pool of water. Move the robotic lawnmower and prevent the
collection of water in the working area.
No loop signal
The power supply is not connected. Check the wall socket connection and wheth-
er an earth-fault breaker has tripped or not.
Check that the low voltage cable is connected
to the charging station.
The low voltage cable is damaged or not con-
nected.
Check that the low voltage cable is not dam-
aged. Check that it is also properly connected
to the charging station and to the power sup-
ply.
The boundary wire is not connected to the
charging station.
Check that the boundary wire connectors are
fitted properly to the charging station. Re-
place connectors if damaged. See
Connect-
ing the boundary wire on page 18
.
Boundary wire broken. Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler. See
Find breaks in the loop wire on page 48
.
ECO mode
is activated and the robotic lawn-
mower has attempted to start outside the
charging station.
Place the robotic lawnmower in the charging
station, press the START button and close
the hatch. See
Settings on page 29
.
The boundary wire is crossed on its way to
and from an island.
Check that the boundary wire is laid accord-
ing to instructions, e.g. in the right direction
around the island. See
Installation on page
26
.
The connection between the robotic lawn-
mower and the charging station has been
broken.
Place the robotic lawnmower in the charging
station and generate a new loop signal, see
New loop signal on page 26
.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
Try moving the boundary wire.
Trapped
The robotic lawnmower has got caught in
something.
Free the robotic lawnmower and rectify the
reason for it becoming trapped.
The robotic lawnmower is stuck behind a
number of obstacles.
Check if there are any obstacles which make
it hard for the robotic lawnmower to move on
from this location.
307 - 002 - 11.10.2017 Troubleshooting - 43
43

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gardena SILENO plus R160 Li-LiC bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gardena SILENO plus R160 Li-LiC in de taal/talen: Engels als bijlage per email.

De handleiding is 7,73 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Gardena SILENO plus R160 Li-LiC

Gardena SILENO plus R160 Li-LiC Gebruiksaanwijzing - Nederlands - 56 pagina's

Gardena SILENO plus R160 Li-LiC Gebruiksaanwijzing - Deutsch - 56 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info