11
GB
3. Select number of watering lines (2 to 6) with rotary button
(e.g. 4) and confirm with the OK button.
The message
Select programme no.
is shown.
Prog
and the programme numbers flash on the display.
On initial programming, the following Step 4 will be skipped to
ensure that all active channels are programmed.
4. Select the desired programme number with the rotary button
(e.g. 1) and confirm with the OK button.
The message
Set watering start time
is shown.
Start
and the watering-start-time hours flash on the
display.
5. Set watering start time (e.g. 18:00 ), watering duration
(e.g. 0:10 ) and watering cycle (e.g. 24h) (refer to
“Set watering programme”
from Step 3 on).
The message
YES / NO
is shown.
OFF
flashes on the display.
6. Select sensor activated (ON) or deactivated (OFF) with the
rotary button (e.g. ON) and confirm with the OK button.
The next higher programme number flashes on the display.
If all programmes have been entered, the watering programmes
still need to be activated, see
“Activate watering programmes”
.
•The maximum watering duration is 2 hrs 59 min.
•All watering sessions must take place within 1 day (last watering
ends at 23:55).
•An overlapping of a watering programme is shown in the info-
line. After a programme has been set that overlaps with the next
one, the watering duration of the following programme will be set
to 1 min.
•If the number of active watering lines is reduced, the remaining
lines will be deleted.
•If the number of watering lines is increased, all programmes will
be reset.
•Manual watering via the MAN button is not possible; however,
active watering can be interrupted.
•The sensor assignment per programme will be asked and pro-
grammed even when a sensor is not connected. When a sensor
is not connected, no sensor will be shown on the normal display.
•If the sensor has been deactivated for a programme, irrigation
will always be carried out regardless of the sensor and the
display will only show Sensor without ON/OFF.
3.
4.
5.
6.
Instructions for
Prog 15
:
