19
Assembly
• During assembly, do not reach into the cutting unit. The blade is very sharp, you could
injure yourself. Before you start work, you have to attach the collecting bin (for smaller
cuttings) or the collection system (for larger areas) consisting of the adapter, hose, and
collecting bag to the device.
Mounting the collection system
1. If the collecting bin is already mounted on the device, fold the locking lever to the out-
side and remove the bin.
2. Set the device down so that the blade is pointing up and hold it in place with one hand
on the handle.
3. If necessary, fold the locking lever to the outside with your other hand.
4. Carefully set the wider end of the adapter on the opening on the side of the cutting
head. Make sure that the adapter end is inserted in the corresponding brackets on the
cutting head.
5. Push the top of the adapter down so that the pin on the bottom of the locking mecha-
nism audibly locks into place.
6. Fold the lever back to its previous position and push it into the indentation on the adapter.
7. Make sure that the adapter is securely seated.
8. Fit the collecting hose on the adapter and apply the Velcro fastener. The fastener should
be pulled as tight as possible around the adapter to prevent the hose from slipping.
9. Connect the collecting hose and bag with the zipper.
Mounting the collecting bin
1. Set the device down so that the blade is pointing up and hold it in place with one hand
on the handle.
2. Fold the locking lever to the outside with your other hand.
3. Set the collecting bin on the device with the vents up and the wider, open side pointing
towards the cutting head.
4. Push the bin under the cutting head until it locks into place and then push it down from
above. A pin is located on the bottom of the bin. It must audibly lock into the device’s
locking mechanism.
5. Fold the lever back to its previous position and push it into the indentation on the adapter.
6. Make sure that the adapter is securely seated.
English
