16
Spray arms
Lime and remnants of food in the washing water can
block the nozzles in the spray arms
22 and 23 and
the arm mountings .
Inspect the nozzles in the spray arms for blocked
holes due to remnants of food.
If necessary, pull the lower arm 23 upwards and lift
it off.
Unscrew the upper spray arm 22 .
Clean both spray arms under running water.
Refit the spray arms. Ensure that the lower arm has
locked into place and the upper one is screwed tight.
Pump *
* on applicable models
Larger remnants of food that have not been trapped by
the filters and have been left in the water can cause a
blockage in the pump. The water is no longer pumped
out of the dishwasher and it can be seen covering the
filter.
Proceed as follows:
First, always disconnect the appliance from the
power supply.
Ladle out as much water as possible.
Remove the filters 25 .
Undo the screw in the cover (Torx T 20) and remove
the cover.
Inspect the inside and remove any obstructions that
you find.
Re-insert the cover and screw down.
Re-insert the filters and screw down.
Fault finding
Resolving minor problems yourself
Experience has shown that you can resolve most
problems that arise during normal daily usage yourself,
without having to call out a service engineer. Not only
does this save costs, but it also means that the
appliance is available for use again that much sooner.
The following list of common occurrences and their
remedies should help you identify the causes of most
problems.
Problems ...
Attention
Remember: Repairs may be carried out by a technician
only. If a component has to be replaced, ensure that
only original spare parts are used. Improper repairs
or use of non-original spare parts may cause
considerable damage and put the user at considerable
risk.
... when the appliance is switched on
The appliance does not start.
The mains fuse has tripped.
The appliance plug has not been inserted.
The appliance door has not been shut properly.
The tap has not been turned on.
The filter on the water supply hose is blocked.
Switch off the appliance and pull out the mains
plug. Turn off the tap. Then clean the filter which
is situated at the connection of the supply hose.
Finally, restore the power, turn on the tap and
switch on the appliance.
... with the appliance itself
Lower spray arm rotates with difficulty
Spray arm is blocked by small items or food
remains.
Lid in detergent compartment cannot be closed
Detergent compartment has been overfilled.
Mechanism is clogged with remnants of
detergent.
Indicator lamps do not extinguish after washing
has finished.
Indicator lamps do not extinguish after
washing has finished
Main switch is still set to ON.
Remnants of detergent stuck inside dispenser
Compartment was damp when it was filled up
with detergent. Compartment must be dry
before detergent is added.
