Attention
Please note that a visit by the customer service
technician in the event of a fault or one of the problems
previously discussed is not free of charge even during
the warranty period.
Information
Notes on comparison tests
You will find details of the conditions for the comparison
tests on the additional ”Notes on comparison tests”
sheet. The consumption values for the relevant
programmes are given in the introduction.
General
Built-under and integrated appliances which are
subsequently installed as free-standing appliances
must be secured to prevent them from falling over,
e.g. by screwing them to the wall or by installing
them under a continuous worktop which is screwed
to the adjoining units.
For Swiss version only:
The appliance can be installed without difficulty
between wooden and plastic walls in a kitchen
range. If the appliance is not connected via a plug,
the installation side must feature an all-pole
disconnector with a contact gap of at least 3 mm in
order to satisfy the relevant safety regulations.
Installation
The dishwasher must be connected by a qualified
technician to ensure correct operation. The
specifications for supply, drainage and connected load
must fulfil the required criteria as stated in the following
paragraphs or in the installation instructions.
Install the appliance in the following sequence:
– Check the delivery
– Install the appliance
– Connect the waste water
– Connect the fresh water
– Connect the power supply
Delivery
Your dishwasher was checked at the factory to ensure
that it was in perfect working order. This may have left
some small water stains in the dishwasher. These will
disappear after the first rinse cycle.
Installation
The required installation dimensions can be found in
the installation instructions. Using the height-adjustable
feet, adjust the appliance until it is level. Ensure that
the appliance is standing firmly.
Waste water connection
See the installation instructions for the required
connection steps. If required, attach a siphon with
drainage spigot. Using the enclosed parts, connect the
waste water hose to the drainage spigot of the siphon.
Ensure that the drainage hose is not kinked, crushed or
twisted (ensure that there is no sealing cover which
prevents the waster water from flowing away!).
Fresh water connection
Using the enclosed parts, connect the fresh water
connection to the tap according to the installation
instructions. Ensure that the fresh water connection is
not kinked, crushed or twisted.
When replacing the appliance, always connect a new
water supply hose to the water supply. The old supply
hose must not be re-used.
Water pressure:
Minimum 0,05 MPa (0,5 bar) – maximum 1 MPa (10
bar).
If the water pressure is higher, install a pressure
reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water.
If you do use hot water, the temperature should not
exceed 60 °C.
