3
INSTALLING YOUR REFRIGERATOR
These instructions were provided to aid
you in the installation of your refrigerator.
The manufacturer cannot be responsible
for improper installation.
Steps to follow…
A qualified engineer must connect
refrigerator in accordance with these
installation instructions. Measure door
opening and depth and width of
refrigerator. Remove handles or doors if
required. Engineer must also do the
following:
1. Follow local water and electrical
company connection regulations.
2. Complete water supply connection
before electrical supply connection.
Service to or replacement of power
cord must be performed by a qualified
servicer.
1. Install on an earthed outlet with a
separate 220-240 volt, 50hz., 10A
circuit.
2. Protect soft flooring with cardboard or
rugs.
3. Provide 5 mm clearance at side of
refrigerator and for models more than
60 cm deep, provide 12.7 mm
clearance at top and back of
refrigerator.
4. 60 cm deep models.
Tr im corners of counter top to a 45°
angle if counter top has 25 mm
overhang.
How to remove wooden
base
To avoid personal injury or property
damage, two people must remove
wooden base.
CAUTION
1. Tape doors shut to prevent doors
from opening unexpectedly.
2. Slide appliance cart under side of
refrigerator.
3. Wrap refrigerator with blanket or pad.
Thread strap around refrigerator. Put
foam shipping pads, located in
shipping carton, under strap.
Tighten strap securely.
4. Lower appliance cart to floor with
appliance cart handles on bottom.
5. Remove top two bolts from skid.
6. Return refrigerator and appliance
cart to an upright position. Remove
strap.
7. Slide appliance cart under opposite
side of refrigerator.
8. Repeat steps 3–5.
9. Remove wooden base.
10. Return refrigerator and appliance
cart to an upright position and
remove appliance cart.
IMPORTANT: Do not leave refrigerator
on its side longer than necessary to
remove bolts.
