25
Warm water connection *
* depending on model
The dishwasher can be connected to cold or hot water
up to max. 60 °C.
Connection to hot water is recommended if the hot
water can be supplied by energetically favourable
means and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting ‘:‹‚ allows you to adjust your
appliance optimally to operation with hot water.
It is recommended to have a water temperature
(temperature of the incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect the appliance to hot
water if the water is supplied from an electric boiler.
Setting hot water:
1 Open the door.
2 Switch on ON/OFF switch (.
3 Hold down programme button # and press
START button )" until •:‹... is indicated on the
digital display.
4 Release both buttons.
The LED for button # flashes and the digital
display 8 displays the factory setting •:‹….
5 Press programme button # until the factory set
value ‘:‹‹ is indicated on the digital
display 8.
To change the setting:
1 By pressing the 3 button, you can switch the
hot water setting off ‘:‹‹ or on ‘:‹‚.
2 Press START button )".
The set value is saved.
3 Close the door.
Electrical connection
Connect the appliance to an alternating current
only, ranging from 220 V to 240 V and 50 Hz or
60 Hz via a correctly installed socket with
protective earth conductor. See rating plate for
required fusing 9:.
The socket must be near the appliance and freely
accessible following installation.
The connection may be modified by technicians
only.
A power cord extension may be purchased from
customer service only.
Use only a residual current operated circuit-
breaker which features the symbol ‚. Only this
extension guarantees compliance with the
currently valid regulations.
The appliance features a water damage protection
system. Please note the system will not function
unless the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
1 Disconnect the appliance from the power supply.
2 Turn off the water supply.
3 Disconnect the waste water and fresh water
connections.
4 Loosen the fastening screws under the worktop.
5 If fitted, remove the base panel.
6 Pull out the appliance, carefully pulling the hose
behind.
