32
Installation
The extractor hood is designed for installation on
the kitchen ceiling or on a rigid suspended ceiling.
•
During installation, optional accessories may
also require fitting.
•
Observe the minimum distance between hob
and extractor hood (see ”Safety instructions”)!
•
Avoid damaging the sensitive surfaces!
Preparing the ceiling
ṇ RISK OF INJURY,
DAMAGE TO PROPERTY
Before drilling the holes for the designated
installation location, check for concealed electrical
cables and other lines.
•
The ceiling must be level and horizontal.
•
The enclosed screws and wall plugs are
suitable for concrete and natural stone. Use the
appropriate fasteners for other ceiling
structures.
Ensure that the ceiling has adequate load
bearing capacity.
•
Ensure that the depth of the drilled holes
corresponds with the length of the screws.
•
Ensure that the wall plugs are secure.
Max. weight: 50 kg.
Design subject to modification in line with technical
development.
Note:
the extractor hood is to be installed to a kitchen
ceiling or suspended ceiling. Ensure that the ceiling
is capable of providing a firm hold for a maximum
weight of hood and accessories of 45 kg.
Before marking the securing holes, make sure that
no electricity wires or water pipes or other wires/
pipes are laid at the drilling points in the ceiling.
Before installation check the enclosed wall plugs
and screws are suitable for your ceiling. If
necessary use special wall plugs.
Installation of the extractor hood:
1 Using the drilling template mark the position of
the screws on the ceiling.
2 Drill 4 holes Ø 8 mm for the wall plugs. Push
the plugs flush with the ceiling.
3 Turn two screws to a 10 mm gap. Both screws
are placed in a position, in which at a later
stage of the installation the key-holes of the
supporting frame are found (namely back left
and front right from the control panel of the
hood).
