Observe Important Wiring Information
Important: This switch is rated for and intended to only be used
with copper wire.
The home’s electrical wires may be attached to the screw
terminals or inserted into the holes in the back of the switch
enclosure and clamped in place by tightening the screw terminals.
Always follow the recommended wire strip lengths when making
wiring connections.
Wire strip length:
• For attachment to screw terminals: Strip insulation 1” (max 14
AWG wire).
• For attachment using the enclosure’s holes: Strip insulation 5/8”
(max 14 AWG wire).
You should now be able to use the rocker to manually turn On/Off
or adjust the brightness of the connected load.
Use your primary controller to include the switch in the home control
network after the switch is wired as shown in the above diagram. It
can then be added to groups and/or lighting scenes and managed
remotely to control the On/Off/Dim status of the connected lighting.
Air Gap Switch
During normal operation, there is a small amount of power
passing through the switch to the load even when the switch
is turned off. The 45639 has an air gap switch on the lower left
side (see diagram for location) to completely disconnect power
to the load. Pull the air gap switch OUT to disconnect the power
while replacing light bulbs and push it all the way back in for
