781824
39
Verklein
Vergroot
Pagina terug
1/87
Pagina verder
Original User Manual Generator FX-SG Series
38
Unscrew the oil filter cup.
Blow out the oil filter cup thoroughly
with compressed air against the
direction of the arrow.
Place new rubber sealing ring on
sealing surface of oil filter cup and
screw oil filter cup back in.
Troubleshooting
The engine will not start.
Check whether the on/off switch or the
key switch (for generators with electric
starter) is in the operating position -
"ON" position.
Check the engine oil level. If the oil
level is too low, the engine cannot be
started.
Check if there is fuel in the fuel tank.
Disconnect the spark plug connector,
remove the spark plug with the spark
plug wrench and check its condition.
Use a wire brush to remove soot
particles from the spark plug and
electrodes.
Check the electrode gap and adjust
it to 0.7 to 0.8 mm if necessary.
The generator does not produce
any current.
Connect a hand lamp to the generator
to check.
Check that the AC fuse switch is in
the "ON" position.
CAUTION!
Observe:
If the generator still does not start 0or does
not generate power, contact your dealer or
an authorized service shop for further
troubleshooting.
Cleaning instructions
Neglecting cleaning measures may lead to
material damage and malfunctions.
Do not spray the power generator
with water.
Keep ventilation slots clean and free of
dust.
Use a soft cloth and a soft brush for
cleaning the exterior.
Clean the tank cover seals regularly
and replace them if necessary.
Storage
NOTE!
Always store the power generator in a
clean, dry, and frost-free place.
If the current collector is to be stored for a
more extended period, proceed as follows:
Shut off fuel tap and unscrew oil filter
cup counterclockwise, drain and blow
out clean.
Position a suitable drain container under
the drain, open the fuel tap, and drain
the fuel entirely into the box.
Replace a sealing ring (rubber) and
screw the oil filter cup back in
clockwise.
Loosen carburettor drain plug and drain
residual fuel from the carburettor into a
suitable container. Tighten carburettor
drain plug again.
Unscrew the oil filler cap, unscrew the
oil drain plug and completely drain oil
from the crankcase into a suitable
container.
Retighten the oil drain plug and fill it
with suitable engine oil up to the
dipstick's upper mark. Screw the oil
filler cap back into the oil filler neck.
Pull until resistance is felt.
Pull the starter rope in doses until
resistance is felt.
CAUTION!
Keep the power generator clean.
39

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Fuxtec FX-SG7500B bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Fuxtec FX-SG7500B in de taal/talen: Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 4.39 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info