Original Bedienungsanleitung FUXTEC FX-MS152 / FX-MS162_de_en_fr_ita_rev16
49
NOTE: If the engine does not start after repeated attempts, please read the
troubleshooting chapter.
NOTE: Always pull the starter cord straight out. Pulling the starter at an angle will cause
the rope to rub against the eyelet. The oblique pulling can cause the starter cable to fray
or break. Always hold the starter handle firmly when the rope is pulled back. Never allow
the rope to be thrown back from the pulled-out position. This could damage the starter
device.
30. Warm start of the engine
1. Place the device on a firm and flat surface.
2. Slide the engine stop switch down.
3. Slide the choke to the "WARM START" position.
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, mainly fast pull will provide a strong spark and start the
engine.
If the engine does not start, please proceed again according to "Cold starting the
engine."
31. Stopping the device
Unlock the throttle. Let the engine return to neutral. Move the engine stop switch on the
handle upwards until it stops. If it does not stop, pull out the spark plug connector in an
emergency. Never leave the device unattended while it is running.
32. Trimming techniques
ADDITIONAL SAFETY INSTRUCTIONS
Before running your device, read notes in chapters 3 and 4 of this manual.
CAUTION
IF YOU are NOT familiar with the trimming techniques, practice with the DEVICE in the
"STOP" position (turned off).
ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS. Never run the device slowly at the
beginning of (or during) trimming operation.
ALWAYS MAKE AWAY DISTANCE IN THE WORKING AREA from cans, bottles, rocks, etc.
