Original Bedienungsanleitung FX-4MS142_de_en_fr_ita_rev01
47
from the pulled-out position. This could damage the starter device.
23. Warm start of the machine
1. Place the device on a firm and flat surface.
2. Move the engine stop switch down
3. Slide the choke to the "WARM START" position
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous high-speed train will provide a strong spark and start the engine
If the machine does not start, please proceed again according to "Cold start of the machine
STOP MACHINE
Unlock the throttle lever. Let the machine return to idle. Push the engine stop switch until the
machine stops.
ADDITIONAL SAFETY INSTRUCTIONS
Before running your machine, repeat GENERAL SAFETY INSTRUCTIONS in this manual.
CAUTION
IF YOU are NOT familiar with the trimming techniques, practice with the MACHINE in the "OFF"
position.
ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS. Do not run the machine slowly at the
beginning or when trimming.
ALWAYS MAKE DISTANCE IN WORKING AREAS from cans, bottles, rocks, etc. Striking objects
can cause serious injury to users or bystanders and can also damage the machine. If an object is
accidentally struck, immediately stop the MACHINE and check the device. Never run the machine
with damaged or defective parts.
DO NOT use the machine for any purpose other than trimming grass.
NEVER lift nylon cutting head above knee height when operating.
Do not run the machine on a slope if there is a chance of slipping or losing stability.
RELEASE OF THE NYLON CUTTING HEAD
To release fresh thread, leave the machine at full power and "push" on
Run nylon cutting head against the lawn. The thread releases automatically. The
blade in the
protective shield cuts off excess thread.
CAUTION: Remove grass deposits regularly to prevent overheating of the drive
axle. Grass build-up occurs when weed fibers become entangled around the shaft
under the protective shield. This condition prevents the shaft from cooling correctly.
Remove grass deposits with a screwdriver or similar tool only when the machine is
