Name and Handling of Each Part
Transmitter T6YG (Front Panel)
Power switch: Turns the transmitter "On" or "Off". In the upper position, the power is turned "On".
Voltage indicator: This is an expanded scale voltmeter. It is not calibrated in volts. When the needle deflects to the
boundary between the silver and red zones, recharge or replace the battery. Do not operate the transmitter if the needle
descends into the red area.
Antenna /Aerial: Never operate the transmitter without extending this antenna or you may create interference to other
modelers. This antenna is not intended to be removable.
Aileron, Elevator, Throttle and Rudder stick: Control each function. See page 14 for the transmitter operation
instructions.
Aileron, Elevator, Throttle and Rudder trim: Used to shift the neutral or idle position of the each servo. As the
throttle stick is moved up towards the high throttle position, the throttle trim will have less effect.
Carrying handle: Provides an easy means of transporting the transmitter.
Neck strap hook: Only clip the neck strap to this hook when neck strap use is required.
Servo reversing switches: Switches that reverse the direction of operation of the servos. The lower position is the
normal side and the upper position is the reverse side.
-10-
Rudder trim
lever
Neck strap
hook
Servo reversing
switches
Throttle ATV
adjustments
Elevator D/R
Aileron D/R
Crystal
Cover
Channel display
1 :Aileron (CH1)
2 :Elevator (CH2)
3 :Throttle (CH3)
4 :Rudder (CH4)
<Operating direction display>
REV :Reverse side
NOR :Normal side
5 :Landing gear (CH5)
6 :Flap (CH6)
Voltage indicator
Antenna /Aerial
Carrying handle
Elevator/Aileron
Dual Rate
switch (ELV/AIL D/R)
Landing gear
switch (Ch.5)
Trainer switch
Throttle (Mode 2)
/Rudder stick
Elevator (Mode 2)
/Aileron stick
Elevator trim lever
(Mode 2)
Throttle trim
lever (Mode 2)
Channel 6
Power switch
Aileron trim lever
NOTE: This graphic shows
the default assignments for
a Mode 2 aircraft system as
supplied by the factory.
