1414
CONNECTION
Note: Ensure the audio system is off during the installation of FUSION product. Once the
installation is complete FUSION recommends that you turn the volume of the source unit up
slowly so not to damage the speakers. Please recheck the complete installation prior to turning
the audio system on.
POWER
FUSION amplifiers should be wired directly to the vehicle battery using the appropriate sized
cable. Start at the vehicle battery and run the power cable through to the amplifier. FUSION
recommends the use of grommets when passing the power cable through any metal wall, and to
avoid sharp corners or sharp body parts that may easily cut through the insulation on the cable.
Avoid running the power cable over engine components or near heater cores. The use of an
inline fuse or circuit breaker is essential. This will prevent the risk of a potential fire caused by
a short circuit in your power cable. Connect the fuse holder or circuit breaker as close to the
battery positive terminal as possible. Use a fuse or circuit breaker of equal value as that found
on the chassis of your FUSION amplifier. You may now connect the cable to the battery, but
remember to leave the fuse out or circuit breaker off until all other cable connections are made.
POWER TERMINAL BLOCK
