TUNER SOURCE SCREENS
AM/FM
An example of a typical tuner input source screen is shown in Figure 2 below.
Figure 2 – Example source screen (AM input selected)
LISTENING TO THE TUNER
To select one of the available tuner bands:
Press the Input source key ( ) to select input from each of the following in turn:
• AM
• FM
The applicable input source screen is displayed for each band.
Continuing to press the key will display the input source screens for iPod (if connected) and
Auxiliary as described in the section “Input Source Screens” on page 6.
TUNER
SIGNAL
STRENGTH
TUNING
MODE
SOURCE NAME
SELECTED
FREQUENCY
23
To select the required display language:
1. Press the Menu key.
2. Turn and then press the Encoder to select Settings > Language.
3. Turn the Encoder to highlight the required language.
4. Press the Encoder to select the highlighted language.
5. Press the Menu key (or leave to time out) to save the setting and exit.
Power save
If you are operating the RA50 on battery power, you can turn on the power save option to
reduce drain on the battery. The LCD screen shuts down automatically after 1 minute of
inactivity (press any key to restore display).
To enable or disable power saving mode:
1. Press the Menu key.
2. Turn and then press the Encoder to highlight Settings > Power save.
3. Press the Encoder to turn on power saving ( ) or turn off power saving
( ).
4. Press the Menu key (or leave to time out) to save the setting and exit.
Tuner region
Use this option to select the correct region to ensure the RA50 tunes correctly to your local
radio stations.
To change the tuner region setting:
1. Press the Menu key.
2. Turn and then press the Encoder to select Settings > Tuner region.
3. Turn the Encoder to highlight the required region:
• Europe
• USA (default region)
• Japan
• Australasia.
4. Press the Encoder to select the region ( ).
5. Press the Menu key (or leave to time out) to save the setting and exit.
