to be used when SmartStick is installed.
for replacement brackets.
mounting bracket.
(refer to Figure B).
before proceeding.
SmartStick is installed.
NOTICE
The sensor (item 4) may be
mounted in an inverted/flipped
position to allow the cable to
exit on the port side. In either
case the magnet arrow MUST
point in the same direction as
the arrow on the decal of the
sensor.
NOTICE
If interference occurs, check fit with other holes.
Model No. RED BLACK WHITE
AR4502, Furuno and Power (5 Volt) Ground Signal (0.5 V – 4.5 V)
most other autopilots
AR4502RM, Ray Marine Power (5 volt) Ground Signal (2.2 V – 2.8 V)
installations ONLY
AR4502SI, Simrad Power Ground N/A
installations ONLY
Using an assistant, check for unrestricted steering
articulation throughout engine trim/tilt positions.
The SmartStick rudder
reference unit will ONLY
mount to Evinrude and
Yamaha 4-Stroke engines
when using a HC5358
front mount cylinder.
CAUTION
WARNING