596216
15
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
9
3. ADJUSTMENTS
3.1 Installation Check
After installing the system it is a good idea to
check it for proper installation, following the
checklist provided below.
Cable gland is facing toward the stern.
Four fixing bolts securing the antenna unit
are securely tightened.
The antenna cable is waterproofed at the
base of the antenna unit.
The antenna cable is securely retained
against the mast or mounting and is free of
interference from running rigging.
The cable gland on the deck or bulkhead is
waterproofed, if provided.
Connectors of external equipment are
securely plugged into the radar display unit.
The power connections to the battery are of
correct polarity.
3.2 Exchanging Display
Unit of Previous
Model
When exchanging the display unit of the
MODEL 1621/1621 MARK-2 with that of the
MODEL 1622, it is necessary to maintain the
magnetron warmup time. This should be done
with the radar in stand-by.
1. Press and together for about 10
seconds to show the display shown in
Figure 19.
NAV DATA (NMEA 0183)
GLL BWR BWC GLC GTD
RMA RMG RMC VTG MTW
DBT DBS DPT GGA
PROGRAM NO
03591610XX
SEL MENU
BY KEY
MAIN
DEMO
/
MODEL M1622 M1621/M2
DISPLAY
1
2
Figure 19 Maintenance menu
2. Select MODEL by
.
M1622: 1 minute.
M1621/M2: 1minute and 30 seconds.
3. Select M1621/M2 by
4
.
4. Press the [MENU] key to close the menu.
3.3 Adjustments
Do the following in order to adjust the radar.
1) Adjustment of picture
1. Press the [POWER] key on the display unit.
The display should light. In approximately
one minute, ST-BY appears at the screen
center.
2. When ST-BY appears press the [TX] key.
The radar will start transmitting, and you
will probably see some targets, even
though the radar is not yet properly
adjusted.
3. Adjust the sensitivity to display a small
amount of noise on the screen.
4. Press the [–] key several times to select
the minimum range. Adjust the STC to
display nearby radar targets clearly on the
screen. Too much STC action will eliminate
small targets, and too little STC action will
cause the screen to be so full of targets
and noise that it is hard to determine which
target is which as compared to visual
sightings.
2) Heading alignment
You have mounted the antenna unit facing
straight ahead in the direction of the bow.
Therefore, a small but conspicuous target dead
ahead visually should appear on the heading
mark (zero degrees).
In practice, you will probably observe some
small error on the display because of the
difficulty in achieving accurate initial positioning
of the antenna unit. The following adjustment
will compensate for this error, up to ±30
degrees.
15

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Furuno 1622 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Furuno 1622 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Furuno 1622

Furuno 1622 Gebruiksaanwijzing - English - 35 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info