27
Cooling
• In order to use the cooling function, you do not need to connect the
water drainage hose. To install the window seal kit, follow the steps
described in the chapter ‘Window Seal’ on the next page.
• Screw on the connector for the air conditioner on one end and the
connector for the window seal kit on the other end of the outlet hose.
• Slide the connector for the air conditioner into the appropriate slot on
the rear of the unit.
• Secure the other end of the outlet hose in the window panel opening so
that it can remove hot air outside.
• You can also hang the outlet hose out of an open window; this method
is less efcient however.
• Avoid bends or pinches in the pipe. These will lead to a build-up of
damp, waste air which can cause leaks, overheating or lead to the air
conditioning unit switching off.
• Warning! Do not use your air conditioner before it is installed according
to the instructions described above!
• Warning! Ensure that no water can enter the device!
• Warning! The length of the drain pipe is specially adapted to the
technology of this air conditioning. Do not replace it, therefore, and
do not extend it with its own hose, as this can negatively affect the
functioning of the air conditioner. The hose can be stretched, but in
order to achieve an optimal effect you should keep the length as short
as possible.
• Remember your intrusion prevention!
