OPERATION
SA5
41
Double Dial-In for Operation with an External
Answer-Phone:
If he Remote Access and Control feature is to be
used and the system is operating in conjunction
with an external Answer-Phone then
1
. The internal Answer-Phone will be disabled.
2
. Remote Phone Access and Control must be
enabled.
3
. The number of ‘rings to answer’ for the
Control Panel must be greater than that of
the external answer-phone.
To access the Remote System Control facility the
Control panel has a ‘double dial-in’ feature to
enable the Control Panel to pick-up the phone call
before the external Answer-Phone cuts in. The
‘double dial-in’ procedure operates as follows:
1
.Dial up the system and hang up after one or
two rings.
2
.Wait a few seconds and then redial up the
system within 20s, the system will pickup the
phone after 1 ring.
3
. Enter the User Access Code as normal.
Remote Access and Control Functions:
The following functions may be access via the
remote telephone. The system will acknowledge
each signal with a single long beep.
Press to initiate FULL ARM mode.
Press to initiate Part-Arm 1 mode.
Press to initiate Part-Arm 2 mode.
Press to Disarm the system.
Press to turn the Siren OFF.
Press to turn the Siren ON.
Press to to Listen-In via the Control Panel
microphone.
Press to stop Listen-In.
Note: Listen-In will be automatically cancelled
after 5 minutes.
Press to interrogate the alarm status. The
status will be indicated by the following tones
which are repeated at 2s intervals for 15s.
One beep system Armed
Two beeps system Part-Armed
Three beeps Alarm triggered
One long beep system Disarmed
Press to replay messages.
Press to delete all messages.
Press to end the session and Hang up the
Control Panel line.
SIREN SERVICE MODE
In order to remove the Solar Siren from the wall to
change the batteries. It is necessary to place the Siren
into Service mode to prevent the Tamper protection
switch on the Siren operating and triggering an alarm.
When you have completed any alterations to the
system remember to switch the siren back into
Operating Mode.
The siren can be switched into service mode using
either the Remote Control or Control Panel as follows:
Remote Control:
Press and hold the button on the remote
control for approximately 6 seconds.
After approximately 6 seconds the Siren will
produce a single long beep to indicate that it has
switched into operating mode in a Disarmed state.
The button should be released during or
immediately after the long beep, otherwise the
system will switch into an Armed state.
Control Panel:
With the system in Standby Mode with the Power
LED ON.
Press
, ,
to enter Test mode, the Arm and Part-Arm LEDs
will flash.
Press to switch the Siren between Service
Mode and normal Operating Mode. LED 5 will
illuminatw to show that the appropriate signal is
being transmitted.
