INTRODUCTION
MULTIPLE USERS
The system allows for up to 6 Users and a Master User
to be configured. This allows the system Event Log to
maintain a record of which users have armed and
disarmed the system. Each user will have a different
Access Code. In addition a 4 second voice recorder
facility enables the users name to be recorded for use
with the Latch-Key facility.
Only the Master User has access to the programming
functions and is able to configure the system.
Note: Any Remote Control Units on the system will be
recorded as User 6.
SYSTEM ARMING
The system has a full ‘Arm’
and two ‘Part-Arm’ modes.
ARM will ‘Arm’ all zones
while the ‘Part-Arm’ modes
will only arm the zones that
are enabled for the particular part-arm mode.
For example:
The system could be configured such that during night
time, ‘Part-Arm 1’ would arm only zones protecting
the lower floor and outbuildings leaving the upper floor
free for movement without triggering the alarm.
During the day while the property is occupied ‘Part-
Arm 2’ would arm only the zones protecting the
outbuildings. However, when the property is left un-
occupied, the full ‘Arm’ mode will arm all zones to
protect the entire property, (i.e. upper and lower floors
and outbuildings).
ENTRY/EXIT DELAY
When the system is armed with the Exit-Delay
enabled, no alarm signal from any detector on an
active zone will be able to initiate an alarm until the
Exit-Delay has expired. This enables the system to be
armed from within the property and allows time for the
user to exit the property without triggering an alarm. If
the Exit-Delay is disabled then detectors on active
zones will immediately be able to initiate an alarm as
soon as the system begins to arm.
The system Exit-Delay may be configured for between
10 to 250 seconds or disabled completely.
If a detector on a zone with its Entry-Delay enabled is
triggered, then an alarm condition will not occur until
the Entry-Delay period has expired. This allows time
for the user to re-enter the property and disarm the
system before an alarm condition occurs. Generally
only the zones on the main entry route to the property
will be configured with an Entry-Delay. The remaining
zones would be configured with their Entry-Delay
disabled allowing them to immediately initiate an
alarm the instant a detector on the zone is triggered.
The Entry-Delay for each zone may be configured for
between 10 to 250 seconds or disabled completely.
Note: To conserve power and maximise battery life
the PIR Detector will only detect movement if there
has been no movement detected within the previous 2
minutes. Consequently the PIR Detector will not
become active until the protected area has been free
from movement for more than 2 minutes.
ZONES
The system incorporates 6 wirefree Alarm Zones for
the connection of the system detectors that are used
to independently monitor different areas of the
property. In addition to standard intruder protection,
each zone may also be configured to operate in one of
four other modes:
- ‘PANIC/PA’ mode provides 24 hour monitoring of
any Personal Attack (PA) switches incorporated
into the system.
- ‘24-hour Intruder’ mode provides 24 hour intruder
protection for areas/zones where continuous
monitoring is required, (e.g. gun lockers).
- ‘Fire’ mode provides 24 hour monitoring of any
Fire/Smoke detectors incorporated into the system.
- ‘Test’ mode allows a zone to be monitored while the
system is armed. If a detector on a test zone is
triggered an entry will be recorded in the Event Log
but an alarm will not occur.
In addition there is the facility to connect 4 hard
wired zones to the Control Panel, each of which is
INTRODUCTION AND OVERVIEW
SA5 3
