560830
9
Verklein
Vergroot
Pagina terug
1/71
Pagina verder
9
6 Operation
This section only describes the operation of the siren when operating without control panel (single zone).
6.1 Arming the system
When leaving the premises, the system must be armed. Make sure that the siren is in operating mode. Before arming the
system, make sure that all doors and windows are closed and that the available PIR movement detectors are not obstructed.
Make sure that animals are restricted to areas not protected by PIR movement detectors.
6.1.1 Instant-arm mode
The instant-arm mode will immediately arm the system. If the system is armed, activating any security detector will
immediately trigger an alarm. When entering the premises, disarm the system before opening any door or window protected
by a door/window contact detector or entering an area protected by a PIR movement detector. In the instant-arm mode, arm
and disarm the system from outside the premises using the remote control or the remote keypad.
Remote control
Remote keypad
1
Press the button.
Enter the 4-digit ID code. Press the button.
The siren emits one beep. The indicators in the front lens and the learn indicator flash once.
6.1.2 Delay-arm mode
The delay-arm mode will arm the system with a 15-second entry/exit delay. The siren will emit one beep and another beep
after the 15-second delay has expired to allow time to leave the premises before the system is fully armed. When entering the
premises by opening any door or window protected by a door/window contact detector or entering an area protected by a PIR
movement detector, the system will be triggered and the siren will emit one long beep. However, the alarm will not sound until
the 15-second delay has expired. Disarm the system using the remote control or the remote keypad during the 15-second delay.
If an alarm occurs, the siren will sound continuously until the set alarm duration time expires. The alarm will stop and the
system will re-arm. The alarm lockout feature will prevent the system from re-arming after repeating the process three times.
Remote control
Remote keypad
1
Press the button.
Enter the 4-digit ID code. Press the button or the
button.
After the 15-second delay has expired, the siren emits one beep. The indicators in the front lens and the learn
indicator flash once to indicate the system is fully armed.
6.2 Disarming the system
Remote control
Remote keypad
1
Press the button.
Enter the 4-digit ID code. Press the button.
The siren emits two beeps.
Note:
If the system is disarmed and the siren emits ten quick beeps, an alarm has been triggered while the system was
armed.
6.3 Personal attack facility
The user can trigger an alarm at any time in the event of threat or danger by activating the personal attack facility.
Remote control
Remote keypad
1
Press and hold the button for 3 seconds.
Note: On earlier remote control models, slide the
personal attach switch.
Press and hold the button or the button for
3 seconds.
The alarm is triggered. The siren will sound.
6.4 Device tamper
If the battery cover of any device (except remote controls) is removed or if the siren or the remote keypad is removed from the
wall, an alarm will occur immediately even if the system is disarmed (unless the siren is in service mode). The alarm will sound
until the set alarm time expires or the system is disarmed from the remote control or the remote keypad.
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Friedland FGGA04 Series bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Friedland FGGA04 Series in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 1,15 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info