787200
8
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
Infraflex
8
EN
Maintenance
The power supply to the unit must be
disconnected during all service, repair and
maintenance work. Wait until the unit is cold.
The unit has no moving parts so the
maintenance requirement is small, but it must
be kept clean and free from dust and dirt. If
the reector is not clean the thermal radiation
from the unit will decrease and the heater will
become hotter. A large amount of dirt can
cause overheating.
The surface of the reector is sensitive and
must be cleaned with care. If the reector
is dirty it must be cleaned or replaced by a
specialist.
To clean the casing, wipe it with a soft, dry
cloth. If it is very dirty, use a slightly damp
cloth and, if necessary, a mild detergent. Wipe
afterwards with a dry cloth to remove moisture.
Residual current circuit breaker
When the installation is protected by means of
a residual current circuit breaker, which trips
when the appliance is connected, this may be
due to moisture in the heating element. When
an appliance containing a heater element has
not been used for a long period or stored in
a damp environment, moisture can enter the
element.
This should not be seen as a fault, but is
simply rectied by connecting the appliance to
the main supply via a socket without a safety
cut-out so that the moisture can be eliminated
from the element. The drying time can vary
from a few hours to a few days. As a preventive
measure, the unit should occasionally be run
for a short time when it is not being used for
extended periods of time.
Packaging
Packaging materials are chosen with
consideration to the environment and are
therefore recyclable.
Handling of product at end of working
life
This product may contain substances necessary
for the functionality of the product but
Replacing the lamp and silicon sealing
The heat lamp is of the highest quality and
unless it is subjected to mechanical strains in
the form of vibrations and impact it will last for
a long time. The service life is dependent on
the ambient temperature and how the heater
is installed. When the heater is installed freely
and outdoors the temperature will be low and
the life of the lamp can be expected to be in the
region of 5000 hours.
When replacing the lamp, the silicone sealing
connected to the lamp must also be replaced,
it should be replaced beforehand if there are
signs of aging.
The lamp must be replaced by an installer or
other skilled person.
1. Disconnect the power supply.
2. Wait until the unit is cold.
3. Remove the screws (6x) that holds the two
plastic gables.
4. Remove the plastic gables.
5. Disconnect white cables (no other cables
should be disconnected).
6. Remove the screw for the earth connection
from the reector.
7. Apply some denatured alcohol with a cloth on
the lamp beside the silicone sealing before
removing the lamp.
8. Remove the lamp by pushing it out of one
of the silicone sealings until one end is
free, then it can be pulled out of the second
sealing.
9. Replace the silicone sealings to new ones
(make sure that the sealing is properly
assembled).
10. Apply some denatured alcohol on the new
lamp (at least 10 cm in from each end) before
assembly.
battery life.
Always use the same type of batteries when
changing them.
The heater can still be used if the remote
control is missing or not working.
The remote control may not function should
there be a loss of signal between the remote
control and the heater.
Start-up
When the unit is used for the rst time or after
a long period of non-use, smoke or an odour
may result from dust or dirt which has collected
on the element. This is completely normal and
disappears after a short time.
11. Assemble the new lamp and make sure that
the silicone sealing is tight around the lamp
ends.
12. Reassemble the rest of the unit again
and make sure that no cables are pinched
between gables and inner gable.
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Frico Infraflex bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Frico Infraflex in de taal/talen: Engels als bijlage per email.

De handleiding is 2.22 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Frico Infraflex

Frico Infraflex Gebruiksaanwijzing - Nederlands - 10 pagina's

Frico Infraflex Gebruiksaanwijzing - Deutsch - 10 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info