EN-44 Original User Guide | Pedelec Groove Next
PLEASE NOTE
The mains voltage must match the supply voltage of the battery
charger, otherwise there is a risk of damage to the device. The supply
voltageforthechargerisspeciedonthelabelonthebackofthe
device.
Do not charge batteries for a long period if they are already fully
charged or are not being used. Electricalstorms,voltageuctuations
and short circuits can damage the battery.
Keep the battery charger clean. If the contacts are dirty, the dirt can
burn during charging, leaving burn marks. The charger may need to be
replaced in such cases 8.5.1 Cleaning Page EN-46.
8.2 Technical details
Battery voltage 36 V
AC input voltage 100 – 240 V
Frequency 50–60Hz
Max. DC output voltage 42 V
Max. charge current 2 A
Dimensions ( L I W I H) 160 mm I 70 mm I46mm(charger)
Permissible ambient tem-
perature when charging 0 °C to +40 °C
Storage temperature -10 to +50 °C
Recommended storage tem-
perature 18 to 23 °C
Weight 706g(charger)
WARNING
The charger is only intended to be used indoors. Keep the charger
away from rain and moisture. If water gets into the charger, there is
a risk of electric shock. If water has penetrated the casing, unplug
the device immediately and have it checked out by your dealer.
Condensation might form on the charger when the temperature
suddenly changes from cold to warm. When this happens wait about
an hour. This is the time a charger needs to reach the temperature of
the warm surroundings. Prevent this happening by storing the charger
where it is used.
The charger and battery may not be covered during the charging
process. Do not use the charger and battery on materials which can
catch re easily (such as paper and textiles) or within a combustible
environment. This also applies when the battery is charged when
tted to the Pedelec. In this case, the Pedelec must be positioned
so that a potential re cannot spread quickly (exercise caution with
carpeted oors). Do not expose the battery and Pedelec to a direct sun
above 40°C. The charger heat generated during the charge process
representsariskofre.Whenthereissmokeoranunusualsmell,
immediately unplug the mains connector of the charger from the
socket and disconnect the battery from the charger. An overheated
battery is damaged and may not be used again. Always stay with the
charger when it is in use.
Keep battery chargers away from sparks and res. It can explode
causingsevereburnsandres.Furtherconsequencescaninclude
malfunctionsandareducedservicelife.Ensurethereisanadequate
ventilation while charging.
intended for interior use. Keep the charger
away from rain and moisture. If water gets
shock.
Damaged batteries must not be charged.
process. It can also be removed and charged elsewhere.
1. Foldtheprotectivecaptotheside.
2. Connectthechargerplugtothebattery(itclicksintoplace).
3. Insert the mains plug into a power socket.
4. All four LEDs light continually on the battery when it is fully
charged.NoLEDashes.
5. Remove the power cable from the socket after completing the charging
process.
6. Remove the charging cable from the battery charging socket.
