732994
158
Verklein
Vergroot
Pagina terug
1/275
Pagina verder
156
Worn brake pads
The rubber brakes for brake pads are almost all
made with grooves and notches.
The grooves and notches help recognize when
the rubber brakes have been subject to too much
wear and tear. If the grooves and notches aren’t
visible anymore, then you must replace the rub
-
ber brakes.
What to do if the rubber brakes start rubbing
against the rim:
You can use the spring adjusting screws to adjust
the rear spring force in such a way that both rub
-
ber brakes lift from the rim the same way whenev-
er you let go of the brake lever. Finally, make sure
that the brakes are working properly (see chapter
“Adjusting the brakes”).
Brake blocks/pads and rims are wearing parts due
to their use. Have the state of wear inspected at
regular intervals by your FLYER specialist retailer.
Grooves in the brake blocks and embedded points
in the rims help you determine the level of wear.
The brake blocks or rims must be changed when
these grooves or points are no longer visible. Al
-
ways change both brake blocks at the same time.
Adjusting the brakes on the rim
Spring adjust-
ing screws
Spring adjust-
ing screws
Hydraulic rim brakes
Although hydraulic rim brakes require relative
-
ly little maintenance, they need to be regularly
looked at and eventually readjusted.
Due to the wear and tear put on the brake pads,
the brake levers will eventually need to be pushed
down harder to operate. When this happens, you
may have to adjust the rim brakes. As is the case
for most bike models, this can be done by adjust
-
ing a screw or a setting wheel on the brake lever.
Ask your FLYER specialist retailer for details.
Hydraulic rim brakes
To remove the front or rear wheel, you must rst
open the quick release lever on the brakes. To
do this, pull the lever downwards until writing
“OPEN” is read. Now remove the loosened brake
unit from the brake bosses by removing it pulling it
out from your seat. You should now have enough
room to dismount the wheel.
Attaching a new wheel required following this
procedure in reversed order. Before closing the
brakes’ quick releases, the brake must be posi
-
tioned in such a way that the rubber brake pads
touch the middle of the rim when the brakes are in
use. Make sure that on the quick release lever on
the brakes show the writing “CLOSED”.
You should at least perform a brake
test before taking the bike on
public roads again.
New brake pads Worn out brake pads
New rim (with points
to indicate wear)
Worn rims
158

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Flyer RS serie - Panasonic bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Flyer RS serie - Panasonic in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Noors als bijlage per email.

De handleiding is 11,42 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Flyer RS serie - Panasonic

Flyer RS serie - Panasonic Gebruiksaanwijzing - Nederlands - 56 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info