456443
17
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
40069 Zola Predosa (BO) - ITALY
info@finicompressors.it
- GB -
5.12 DTT11 ELECTRONIC INSTRUMENT (DIGITAL TIMER THERMOMETER)
set
Button - access the set-up.
Button - condensate drain test / value increment.
ON
set
LED -
-
glowing = power on.
flashing = set-up condition.
ON
set
set
DISPLAY
LED - condensate drain solenoid valve on.
The DTT11 controller performs a double function : it shows the current operating DewPoint through the
digital led display and it controls the functioning of condensate drain solenoid valve through the cyclic
electronic timer.
OPERATION - During the dryer operation, the LED
ON
set
is on.
The 10 LED display indicates the current operating DewPoint, shown by means of a three colours (blue-
green-red) bar over the display itself.
Blue section - the operative DewPoint of the dryer is low;
Green section - operating conditions ensuring an optimal DewPoint;
Red section - DewPoint of the dryer too high, the treatment of the compressed air may be improper.
The condensate drain solenoid valve is activated for 2 seconds (T
ON
) - LED on - each minute (T
OFF
), if
standard setting.
To perform the manual test for the condensate drain, press the
button.
The "out of scale" conditions are indicated by the intermittent flashing of the first and the last LED of the
display, respectively showing the exceeding of the lower or the upper range.
SET-UP - The DTT11 is adjusted during the final test of the dryer. In case of particular requirements
concerning the operation management, the user can change the setting of the programmed parameters.
The parameters which can be set up are the following :
T
ON
- activation time of the condensate drain solenoid valve.
T
OFF
- pause time between two consecutive activation of the condensate drain solenoid valve.
To access the set-up, keep pressed the
set
button for at least 2 seconds;
ON
set
LED flashing confirms the command.
First appears the T
ON
parameter; to access the other parameters, press sequentially the
set
button.
To change the value of the selected parameter, keep pressed the
set
button and operate on button ;
the current value is shown on the LED display. For the value range and the resolution (value of each single
LED), see the following table :
Parameter Description Display Value
range
Resolution Set
value
T
ON
Activation time of the
condensate drain solenoid valve
Synchronous flashing
LED
ON
set
+LED
1 - 10 sec 1 sec 2 sec
T
OFF
Pause time of the condensate
drain solenoid valve
Non-synchronous flashing
LED
ON
set
+LED
1 - 10 min 1 min 1 min
To exit the set-up condition in any moment, press the button. In case no operations are made during 2
minutes, the system exits automatically the set-up condition.
17

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Finicompressors Artic 134-EVO luchtdroger bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Finicompressors Artic 134-EVO luchtdroger in de taal/talen: Engels als bijlage per email.

De handleiding is 1,04 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info