724603
26
Verklein
Vergroot
Pagina terug
1/42
Pagina verder
4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. DM46P-DO160 • 09/2018 • 60751
(toll free)
24
info.aldi@positecgroup.com
1300 889 028
10/2019 10852
Preparation
Adding and checking the oil
IMPORTANT: The motor of this mower is packed with NO OIL in the motor.
Prior to starting the motor, Oil MUST be added to the sump of the motor.
Failure to add sucient oil will result in damage to the motor which is NOT
covered under the warranty of the mower.
On a new mower, the motor needs to be lled with 350ml of SAE 10W/30
engine oil.
Each time the mower is used, the oil level should be checked and if low, add
sucient oil to ensure the oil level is to the full mark on the oil dipstick (17).
1. Position the lawn mower on a at and level surface. Clean the area directly
around the oil ller cap (17).
2. Remove the oil ller cap (17) by unscrewing it in an anti-clockwise
direction, and lift the cap outwards (Fig M).
Clean the oil dipstick (17) with a clean cloth, cleaning away any visual oil.
NOTE: The cap is a full threaded t.
3. FOR A NEW MOWER, add 350ml of SAE 10W/30 engine oil. Before replacing
the dip stick / ller cap, allow a minute or so to allow the oil in the ller tube
to fully drain of oil.
4. For both a new mower and also a previously used mower, measure the
amount of oil in the motor by re-inserting the oil dipstick back on top of
the ller tube, BUT DO NOT screw the cap in place.
5. After a few seconds, remove and inspect the oil level on the bottom of the
oil dipstick (17). (Fig N)
6. The oil level should be between the low and maximum marked section of
the oil dipstick (17) (Fig O). If the oil level is sucient replace the oil cap by
inserting and screwing back in the oil ller tube in a clockwise direction
until rm.
7. If the oil level is insucient, i.e. the oil level is not on the marked section of
the oil dipstick (17), add further oil in 50ml intervals and repeat steps 4, 5, 6,
and 7 until the correct oil level is obtained.
Always ensure the oil ller cap (17) is rmly locked in place before the
motor is started. Do not over ll with oil above the maximum mark.
Only use SAE 10W/30 engine oil.
Preparation
N.
O.
HIGH
LOW
CORRECT
LEVEL
M.
TIGHTEN
LOOSEN
26

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Ferrex-DM46P-DO160

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ferrex DM46P-DO160 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ferrex DM46P-DO160 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,77 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info